M-C30EV041 Data Sheet USB Evaluation Cable for EPSON IMU OVERVIEW The USB Evaluation Cable enables a PC to control an Epson IMU via USB interface when connected to a USB Evaluation Cable Interface Board (M-G35EV022,M-G32EV031, or M-V34EV021). The USB Evaluation Cable Interface Boards are sold separately. These USB evaluation tools simplify the initial evaluation and rapid testing of the Epson IMU products. BLOCK DIAGRAM VCC 3.3V VCC 3.3V GND GND PC USB USB RTS USB RTS Evaluation Evaluation Epson IMU Cable Interface Cable CTS CTS Board (M-C30EV041) UART TXD UART TXD UART RXD UART RXD Fig1. Block Diagram RECOMMENDED OPERATING CONDITION The USB Evaluation Cable supports PCs running Microsoft Windows 7/ 8.1/ 10(64bit). Other hardware connection or software environments are not tested by Epson. Table1. Recommended Operating Condition Support OS Windows 7 / 8.1 / 10 (64bit) USB Specification 1.1 / 2.0 Operating Temperature Room Temperature CABLE DIAGRAM Connector: CGP1206-0101 (SMK Company) (6) RTS USB to Serial Converter Cable TTL-232RG (FTDI Company) (5) UART RXD To USB (4) UART TXD USB Evaluation To PC Type A (3) VCC 3.3V Cable Interface (2) CTS Board 1.8m (1) GND Fig2. Cable Diagram M-C30EV041 SUPPORTED DEVICES Table2. Supported Devices USB Evaluation Cable USB Evaluation Cable Supported IMU Models Interface Board M-G350PD M-G35EV022 M-G352PD M-G362PD M-C30EV041 M-G354PDH0 M-G32EV031 M-G364PDC0 M-G364PDCA M-V34EV021 M-V340PD Please refer to each specific USB Evaluation Cable Interface Board data sheet for connecting information. SOFTWARE REQUIREMENT FTDI Driver If the driver software (USB Serial Converter, USB Serial Port (COMx)) is requested when the USB Evaluation Cable is connected to the PC, install the driver using either of the following two methods. Update the driver via Windows Device Manager. (Automatic Update over the Internet is recommended.) Access the FTDI website (