MPDV1120RA-GM-LP Finisar

Product Specification 35 GHz SMD Photodetector MPDV1120RA PRODUCT FEATURES XLMD MSA footprint compliant package Waveguide-integrated pin-photodiode Typical 35 GHz bandwidth Single ended AC coupled output APPLICATIONS 43 Gb/s communication systems Transponder and line card designs The single output photodetector module MPDV1120RA contains a waveguide-integrated pin- photodiode (PD), designed to exhibit optimized high frequency performance in both, amplitude and phase. A linear response up to an optical input power of 10 dBm enables to drive subsequent decision circuits of communication systems directly. The pin-photodiode with on-chip integrated bias network in conjunction with a blocking capacitor for AC coupling is the best choice for 44 Gb/s applications. ORDERING INFORMATION MPDV1120RA-GM-LP RA: = single ended, AC coupled output GM: = GPPO compatible, male LP: = LC/PC optical connector (standard) Confidential and Proprietary 2014 Finisar Corporation. All rights reserved Rev. A1 Page 1 35 GHz SMD Photodetector April 2014 I. Pin Description # Pin Symbol Description 1 V photodiode supply bias 2,7 GND ground 3,4 RFU reserved for future use please do not connect, internally connected to ground 5,6,8 NC reserved for future use not connected RF1 NC not connected RF2 Out P positive RF output II. Block Diagram III. Absolute Maximum Ratings Parameter Symbol Condition Min. Typ. Max. Unit Photo Diode Reverse Voltage V -0.3 4 V PD Average Optical Input Power P NRZ 16 dBm opt C= 100 pF, R= 1.5 k, ESD, Output Pins V -250 250 V ESD HBM Fiber Bend Radius 10 mm Notice Stresses greater than those listed under Absolute Maximum Ratings may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. The inherent design of this component causes it to be sensitive to electrostatic discharge (ESD). To prevent ESD-induced damage and/or degradation to equipment, take normal ESD precautions when handling this product. Confidential and Proprietary 2014 Finisar Corporation. All rights reserved Rev. A1 Page 2