PS6-102V-PAR Nidec Copal

PRESSURE SWITCHES WITH GAUGE PS6 INTERNAL STRUCTURE (M5 female screw) marking Compatible with EMC directive 13 2 4 5 6 Part name Material FEATURES Pressure port POM (Polyoxymethylene) 1 Solidstate pressure switch with no mechanical moving parts Housing PC (Polycarbonate) 2 2 types of pressure ports are available Open collector output of either NPN or PNP is available O ring Fluoro-rubber 3 Analog output type available Sensor module board 4 Protection panel 5 PET (Polyethyleneterephthalate) Main panel 6 MODEL NUMBER DESIGNATION P S 6 - 1 0 2 V - N A R Series name Pressure port RR1/8 male screw with M5 female screw MM5 female screw Rated pressure range 102100 kPa 1031000 kPa Output Pressure reference A1 SW output and adjustable hysteresis + Analog output W2 SW outputs GGauge VGauge (Vacuum) Switch output interface NNPN open collector PPNP open collector LIST OF MODEL NUMBERS 102V 102G 103G Pressure port Outputs Switch output 0 ~ 100 kPa 0 ~ 100 kPa 0 ~ 1000 kPa NPN open collector output PS6-102V-NARPS6-102G-NAR PS6-103G-NAR Adjustable hysteresis switch output + Analog output PNP open collector output PS6-102V-PARPS6-102G-PAR PS6-103G-PAR R 1/8 male screw NPN open collector output PS6-102V-NWR PS6-102G-NWR PS6-103G-NWR Switch outputs (2 points) PNP open collector output PS6-102V-PWRPS6-102G-PWR PS6-103G-PWR NPN open collector output PS6-102V-NAMPS6-102G-NAM PS6-103G-NAM Adjustable hysteresis switch output + Analog output PNP open collector output PS6-102V-PAMPS6-102G-PAM PS6-103G-PAM M 5 female screw NPN open collector output PS6-102V-NWMPS6-102G-NWM PS6-103G-NWM Switch outputs (2 points) PNP open collector output PS6-102V-PWMPS6-102G-PWM PS6-103G-PWM Verify the above model numbers when placing orders. PS6 PRESSURE SWITCHES WITH GAUGE STANDARD SPECIFICATIONS Unless otherwise specified, the specs are defined at an ambient temperature of 25 5 C and excitation voltage of 12 V DC. PS6 Item Model number 102V 102G 103G Pressure reference Gauge Rated pressure range kPa 0 ~ 100 0 ~ 100 0 ~ 1000 Maximum pressure kPa 200 200 1500 Break-down pressure kPa 500 500 2000 10 ~ 60 Operating temp. range C Compensated temp. range C 0 ~ 50 Operating humidity %RH 35 ~ 85No condensation Storage temp. C 20 ~ 70Atmospheric pressure, humidity 65 %RH maximum Pressure medium Non-corrosive gases Insulation resistance M min. 100 (500 V DC) Dielectric strength 500 V AC, 60 sLeakage current 1 mA maximum Pressure port R 1/8Female screwor M5 Net weight g Approx. 50Including cable Supply voltage V DC 12 ~ 24 V 10 %Including ripple percentage Consumption current mA max. 35 Display element 2-digit LED Rated display range 0 ~ 99 kPa 0 ~ 99 kPa .0 ~ .99 MPa Display accuracy 0 50 3 %F.S. 2counts Reference temp. 25 C Resolution 1 count No. of outputs 1 or 2 Output interface NPN/PNPOpen collector output (NPN or PNP) Setting method Adjustable by VR 1 Adjustable range 0 ~ 100 of rated pressure 2 Display Red LED ON (W type only : SW1 Red, SW2 Green) Accuracy 0 50 %F.S. 3 Reference temp. 25 C Switch hysteresis Approx. 0 ~ 15 % of the set value (W type only 2 % F.S. maximum) Switching capacity 30 V 80 mA maximum Residual voltage V maximum 0.8 (NPN), 1.2 (PNP) Response ms Approx. 2 Output voltage V 1 ~ 5 Zero voltage V 1 0.1 Span voltage V 4 0.1 Output current mA maximum 1Load resistance 5 k minmum 1Please set adjusting torque at 30 mNm maximum. 2The actual setting range adjustable by VR has a little overrunning margin beyond the rated display of 0 through 99. This could cause the setting value of VR may be under 0 or over 99. Analog output Switch output Display Power General specifications