NLAS4717 Analog Switch, High Bandwidth, Dual SPDT The NLAS4717 is an advanced CMOS analog switch fabricated in sub-micron silicon gate CMOS technology. The device is a dual independent Single Pole Double Throw (SPDT) switch featuring two NLAS4717 GND B 1 VCC 1 10 NO2 NC2 NC1 C A 1 1 NO1 2 9 COM2 IN1 C A IN2 2 2 COM1 3 8 IN2 C A COM1 3 3 COM2 IN1 4 7 NC2 NO1 C A NO2 4 4 B 4 NC1 GND 5 6 VCC Micro10 Flip-Chip-10 (Top View) (Top View) Figure 1. Device Circuit Diagrams and Pin Configurations MAXIMUM RATINGS Symbol Parameter Value Unit V+ Positive DC Supply Voltage 0.5 to 7.0 V V Analog Input Voltage (V , V , or V ) (Note 1) 0.5 V V 0.5 V IS NO NC COM IS CC V Digital Select Input Voltage 0.5 V 7.0 V IN I I DC Current, Into or Out of Any Pin (Continuous) 100 mA IK I Peak Current (10% Duty Cycle) 200 mA PK Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. 1. Signal voltage on NC, NO, and COM exceeding VCC or GND are clamped by the internal diodes. Limit forward diode current to maximum current rating. RECOMMENDED OPERATING CONDITIONS Symbol Parameter Min Max Unit V+ DC Supply Voltage 1.8 5.5 V V Digital Select Input Voltage GND 5.5 V IN V Analog Input Voltage (NC, NO, COM) GND V V IS CC T Operating Temperature Range -40 +85 C A t , t Input Rise or Fall Time, SELECT V = 3.3 V 0.3 V 0 100 ns/V r f CC V = 5.0 V 0.5 V 0 20 CC ANALOG SWITCH DC CHARACTERISTICS -40 C to +85C Min Max Symbol Parameter Condition V (V) Unit CC V Input Logic High Voltage V = 0.1 V 1.65 to 2.2 V x 0.55 - V IH OUT CC 2.7 to 3.6 V x 0.5 - I 20 A OUT CC 4.5 to 5.5 2.0 - V Input Logic Low Voltage V = -V - 0.1 V 1.65 to 2.2 - V x 0.2 V IL OUT CC CC I 20 A 2.7 to 3.6 - V x 0.2 CC OUT 4.5 to 5.5 - 0.8 I Input Leakage Current V V or GND 5.0 -100 +100 nA IN IN CC V Power Supply Range All - 1.65 5.5 V CC I Supply Current V = V or GND 1.8 - 1.0 A CC IN CC I = 0 A 3.3 - 1.0 OUT 5.0 - 1.0 V Analog Signal Range Key parameter - 0 V V IS CC