74HCT173N,652 NXP

INTEGRATED CIRCUITS DATA SHEET For a complete data sheet, please also download: The IC06 74HC/HCT/HCU/HCMOS Logic Family Specifications The IC06 74HC/HCT/HCU/HCMOS Logic Package Information The IC06 74HC/HCT/HCU/HCMOS Logic Package Outlines 74HC/HCT173 Quad D-type flip-flop positive-edge trigger 3-state December 1990 Product specication File under Integrated Circuits, IC06Philips Semiconductors Product specication Quad D-type ip-op positive-edge trigger 3-state 74HC/HCT173 FEATURES synchronously with the LOW-to-HIGH clock (CP) transition. When one or both E inputs are HIGH one n Gated input enable for hold (do nothing) mode set-up time prior to the LOW-to-HIGH clock transition, the Gated output enable control register will retain the previous data. Data inputs and clock enable inputs are fully edge-triggered and must be stable Edge-triggered D-type register only one set-up time prior to the LOW-to-HIGH clock Asynchronous master reset transition. Output capability: bus driver The master reset input (MR) is an active HIGH I category: MSI CC asynchronous input. When MR is HIGH, all four flip-flops are reset (cleared) independently of any other input condition. GENERAL DESCRIPTION The 3-state output buffers are controlled by a 2-input NOR The 74HC/HCT173 are high-speed Si-gate CMOS devices gate. When both output enable inputs (OE and OE ) are and are pin compatible with low power Schottky TTL 1 2 LOW, the data in the register is presented to the Q (LSTTL). They are specified in compliance with JEDEC n outputs. When one or both OE inputs are HIGH, the standard no. 7A. n outputs are forced to a high impedance OFF-state. The The 74HC/HCT173 are 4-bit parallel load registers with 3-state output buffers are completely independent of the clock enable control, 3-state buffered outputs (Q to Q ) 0 3 register operation the OE transition does not affect the n and master reset (MR). clock and reset operations. When the two data enable inputs (E and E ) are LOW, the 1 2 data on the D inputs is loaded into the register n QUICK REFERENCE DATA GND = 0 V T =25 C t =t =6ns amb r f TYPICAL SYMBOL PARAMETER CONDITIONS UNIT HC HCT t / t propagation delay C = 15 pF V =5V PHL PLH L CC CP to Q 17 17 ns n MR to Q 13 17 ns n f maximum clock frequency 88 88 MHz max C input capacitance 3.5 3.5 pF I C power dissipation notes 1 and 2 20 20 pF PD capacitance per ip-op Notes 1. C is used to determine the dynamic power dissipation (P in W): PD D 2 2 P =C V f + (C V f ) where: D PD CC i L CC o f = input frequency in MHz i f = output frequency in MHz o 2 (C V f ) = sum of outputs L CC o C = output load capacitance in pF L V = supply voltage in V CC 2. For HC the condition is V = GND to V I CC For HCT the condition is V = GND to V - 1.5 V I CC ORDERING INFORMATION See 74HC/HCT/HCU/HCMOS Logic Package Information. December 1990 2