PUSBMIC50 PYLE

INTRODUCTION USING HANDHELD MICROPHONE Parts Description With a wireless receiver built into a USB stick and a high-quality handheld dynamic microphone transmitter, this UHF wireless P U S B M I C 5 0 USB microphone brings the convenience of UHF WIRELESS USB MICROPHONE wireless to your karaoke and recordings. It s the ideal wireless system for karaoke, 1 2 3 4 podcasting, YouTube performances, voice over projects and much more. 1. Grille(Capsule inside) 2. Power/low battery Indicator The handheld microphone transmitter 3. Power ON/OFF/MUTE Switch features a high-quality dynamic mic capsule 4. Battery Compartment/Cover designed to provide exceptional sound reproduction for spoken word Operation presentations, as well as singing applications and more. It offers over 60 of 1. Open battery cover. Install the provided wireless range (environment dependent), 2pcs 1.5V AA batteries and then close the operating in UHF 600~960 high frequency cover. Pay attention to the correct band. The wireless receiver is USB powered polarity. and features plug-and-play operation with 2. Push power switch to ON position, power no driver installation required. Simply indicator should flash once briefly connect the receiver directly to your indicating that the transmitter has computer via USB and start singing and sufficient power. If the power LED recording. indicator stays on, it indicates that the battery has insufficient power and should FEATURES be changed. If the power LED indicator does not light at all and the transmitter UHF 600~960MHz high band wireless does not work, it indicates the battery is system dead and you should change the battery. Wireless receiver built into a USB stick 3. Now receiver RF indicator should Handheld dynamic microphone light(Please confirm frequency of transmitter microphone same as that of receiver Transmitter operates on two AA batteries before operation). (included) 4. Push power switch to MUTE position to 60 operating range (environment mute the sound. dependent) 5. If the microphone is not going to be used Plug-and-play operation with no driver for any length of time, push power switch installation required to OFF position and remove the battery. Ideal for computer karaoke, podcasting, USERS MANUAL voice over projects and much more. Record wirelessly to your favorite DAW or voice recognition software on your Mac/PC PLEASE READ CAREFULLY BEFORE OPERATION USING WIRELESS RECEIVER CONNECTION 2(Computer Recording) Plug USB connector of wireless USB Plug USB connector of wireless USB receiver into USB port on a computer. Turn receiver into USB port of Mp3 player in your on handheld microphone and use audio active speaker system. Using supplied 1 2 software in your computer to record. 3.5/3.5 audio cable connect line out of 3 wireless USB receiver to MIC IN or LINE IN of your active speaker. 1. USB connector: Plug into a computer or Mp3 player USB port or 5V power adapter This wireless USB receiver can also be USB to get power. powered by external 5V power adapter(not 2. Line out: to connect to external speaker. supplied) to be used as a wireless 3. RF indicator: When handheld microphone microphone system. PHONE is powered on this LED will light red displaying normal reception. Computer SPECIFICATIONS CONNECTION 1(Computer Karaoke) Frequency Range: 600~960MHz Speaker or Headphone Frequency Response: 100Hz~12KHz Note: Plug USB connector of wireless USB Dynamic Range: >80dB 1. In Recording Mode please set recording receiver into USB port on a computer. Operating Range: 60 (environment device(audio input device) of your computer Connect external speaker to phone out of dependent) to USB Audio Device. USB receiver. Play music from computer and Receiver Power Supply: 5V 2.In Recording Mode please do not connect turn on handheld microphone to start sing a Transmitter Power Supply: 3V(2x1.5V AA headphone or external speaker to phone karaoke song batteries) out of USB receiver. If you want to play Transmitting Power: <10mW recorded file connect headphone or Receiver Output: >300mV external speaker to your computer phone Output Impeadance: 1K out. CONNECTION 3(Working as a Wireless Microphone system) Computer Speaker Note: MIC IN/LINE IN 1. With this connection please set playing EQ device(audio output device) of your computer to USB Audio Device. USB PORT OF MP3 PLAYER 2. With this connection receiver will receive vocal signal from handheld MIC and pass vocal signal directly to LINE OUT to be mixed with music signal from computer via USB connector. Recording is not ACTIVE SPEAKER allowed in this mode. X-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for pyle manufacturer: Other Similar products are found below : PDS442 PSPVC6 PDWM4300 PDWM4400 PDMW6 PDBT28 PDJSD2 PLRSTND10 PLG3.2 PSCRIM2B PSCRIM2W PDWM2115 PDWM1904 PSTND1 PPA15 PPA10 PDS341 PDS122 PDMW5 PLAM40 PFN41 PCT40 PPA6 PDMR6 PPA8 PDS221