AOZ1210AI Alpha & Omega

AOZ1210 EZBuck 2A Simple Buck Regulator General Description Features The AOZ1210 is a high efficiency, simple to use, 2A buck 4.5V to 27V operating input voltage range regulator flexible enough to be optimized for a variety of 70m internal NFET, efficiency: up to 95% applications. The AOZ1210 works from a 4.5V to 27V Internal soft start input voltage range, and provides up to 2A of continuous Output voltage adjustable down to 0.8V output current on each buck regulator output. The output voltage is adjustable down to 0.8V. 2A continuous output current Fixed 370kHz PWM operation Cycle-by-cycle current limit Short-circuit protection Thermal shutdown Small size SO-8 packages Applications Point of load DC/DC conversion Set top boxes DVD drives and HDD LCD Monitors & TVs Cable modems Telecom/Networking/Datacom equipment Typical Application C7 VIN C1 22F VIN BS L1 6.8H VOUT EN LX AOZ1210 R1 C4, C6 VBIAS FB 22F R2 C4 GND COMP R C C C Figure 1. 3.3V/2A Buck Regulator Rev. 1.7 December 2009 www.aosmd.com Page 1 of 14AOZ1210 Ordering Information Part Number Ambient Temperature Range Package Environmental AOZ1210AI -40C to +85C SO-8 RoHS All AOS Products are offering in packaging with Pb-free plating and compliant to RoHS standards. Please visit www.aosmd.com/web/quality/rohs compliant.jsp for additional information. Pin Configuration 1 8 LX VBIAS 2 7 BST VIN 3 6 GND EN 4 5 FB COMP SO-8 (Top View) Pin Description Pin Number Pin Name Pin Function 1 LX PWM output connection to inductor. LX pin needs to be connected externally. Thermal connection for output stage. 2 BST Bootstrap voltage input. High side driver supply. Connected to 0.1F capacitor between BST and LX. 3 GND Ground. 4 FB Feedback input. It is regulated to 0.8V. The FB pin is used to determine the PWM output voltage via a resistor divider between the output and GND. 5 COMP External loop compensation. Output of internal error amplifier. Connect a series RC network to GND for control loop compensation. 6 EN Enable pin. The enable pin is active HIGH. Connect EN pin to V if not used. Do not leave the EN IN pin floating. 7V Supply voltage input. Range from 4.5V to 27V. When V rises above the UVLO threshold the IN IN device starts up. All V pins need to be connected externally. IN 8 VBIAS Compensation pin of internal linear regulator. Place put a 1F capacitor between this pin and ground. Rev. 1.7 December 2009 www.aosmd.com Page 2 of 14