Data Sheet ACD-6 PRO 1000A Clamp-on Multimeter Simple to operate and well-suited for high current applications. 1000 Amp AC current AC/DC voltage to 600V Resistance Continuity Beeper Relative zero mode No hassle Auto power off warranty Data hold Carrying case included No waiting. Large, easy to read digital display No shipping Accommodates conductors up to 45mm charges. (1.77) in diameter Our commitment to high-quality products ACD-6 PRO and customer service is demonstrated by our industry exclusive No Hassle warranty. In the unlikely event that an Amprobe Test Tool requires warranty service, any of our local dealers are authorized to replace it, on the spot. (note: 500 MSLP limit) 600V Amprobe Test Tools www.Amprobe.comData Sheet ACD-6 PRO 1000A Digital Clamp-on Multimeter Electrical Specifications Accuracy is (% reading digits + number of digits) or otherwise specified, at 23 C 5 C (73F 9F) & less than 75% R.H. Range Accuracy DC Voltage 400.0 mV 1.0% + 3d 4.000V, 40.00V, 400.0V 1.7% + 3d 600V 2.0% + 4d NMRR : >50dB 50/60Hz CMRR : >120dB DC, 50/60Hz, Rs=1k Input Impedance: 10M , 30pF nominal (1000M for 400.0mV range) Audible Continuity Tester Open Circuit Voltage: 0.4VDC typical 400.0 1.5% + 6d Audible threshold: between 10 and 120 . Resistance 400.0 1.5% + 6d 4.000k , 40.00k , 400.0k 1.0% + 4d 4.000M 1.5% + 4d 40.00M 2.5% + 4d Open Circuit Voltage: 0.4VDC typical AC Voltage 1) 50Hz -- 500Hz 400.0mV 4.0% + 5d 50Hz -- 60Hz 4.000V, 40.00V, 400.0V 2.0% + 5d 60Hz -- 500Hz 4.000V, 40.00V, 400.0V 2.5% + 5d 50Hz -- 500Hz 600V 3.0% + 5d CMRR : >60dB DC to 60Hz, Rs=1k Input Impedance : 10M , 30pF nominal 1) Selection by RANGE button manually, and is specified from AC 40mV (AC 60mV for True RMS model ACD-6 TRMS-PRO) and up Diode Tester Open Circuit < 1.6 VDC Voltage Test Current (Typical) 0.4mA AC Current (Clamp-on) 50Hz / 60Hz 400.0A 1.5% + 5d 1000A 1.5% + 5d 1) Add 8d to specified accuracy while reading is below 15% of range 2) Induced error from adjacent current carrying conductor: < 0.06A/A 3) Specified accuracy is for measurements made at the jaw center. When the conductor is not positioned at the jaw center, position errors introduced are: Add 1% to specified accuracy for measurements made WITHIN jaw marking lines (away from jaw opening) Add 4% to specified accuracy for measurements made BEYOND jaw marking lines (toward jaws opening) Amprobe Test Tools www.Amprobe.com