600H-600NH series Toggle switches high amperage DISTINCTIVE FEATURES Robust mechanism High current/voltage rating Insulated or metal lever UL, CSA and NF-VDE (EN 61058-1) approved ELECTRICAL SPECIFICATIONS Max. current/voltage ratings : see tables below Peak current : 30 A max. during 1/2 sine, 250 VAC Initial contact resistance : 10 m max. Insulation resistance : 1,000 M min. at 500 VDC Dielectric strength : 2,000 Vrms 50 Hz min. between terminals 2,500 Vrms 50 Hz min. between terminals and frame Electrical life : 10,000 cycles at full load APPROVED RATINGS 600H - 600NH Models Functions UL CSA NF-VDE UL 1054 CSA 22-2 EN 61058-1 ON - OFF (1) 15 A 1/2 HP 10(4) A 125-250 VAC Single and ON - ON (6) 400 VAC double pole Other 10 A 1/2 HP (4-5-7-8-9) 125-250 VAC T 85/55 (600H) ON - OFF (1) 15 A 1/2 HP & ON - ON (6) 125-250 VAC T 125/55 Three pole (600NH) Other 10 A 1/2 HP (5-7-8-9) 125-250 VAC FOR INFORMATION Max. current/voltage rating w. resistive load Functions Ratings Electrical life 15 A 250 VAC ON - OFF 10 A 24 VDC 10,000 cycles ON - ON 15 A 12 VDC 15 A 250 VAC 6,000 cycles ON OFF ON 5 A 24 VDC 10,000 cycles 15 A 125 VAC Other 12 A 250 VAC 10,000 cycles 5 A 24 VDC The company reserves the right to change specifications without notice. 1 SW-600H-600NH-2010 PANEL SWITCHES600H-600NH series Toggle switches high amperage TERMINALS GENERAL SPECIFICATIONS Torque : 1.50 Nm (1.10 Ft.lb) max. applied to nut Panel thickness : 4.5 mm (.177) max. between 2 nuts Operating temperature : -20 C to +55 C (-4 F to +131 F) 600H/2 & 600NH/2 600H & 600NH MATERIALS Case : polyester UL94-V0 Actuator : ELECTRICAL FUNCTIONS - 600H : brass, nickel plated - 600NH : black polyamide KEYWAY Bushing : brass, nickel plated or zinc die-cast (zamak) Contacts : silver/nickel alloy APEM products may be recycled at end-of-life for the re-claiming of valuable metal components. AGENCY APPROVALS PANEL CUT-OUT EN 61058-1 EN 61058-1 Availability : see chart on previous page. Marking : approved models are standard marked. 2 PANEL SWITCHES