DF-G1-PS-Q7 Banner

DF-G1 Expert Dual Display Fiber Amplifier Installation Guide Advanced sensor with dual digital displays for use with plastic and glass fiber optic assemblies. For complete technical information about this product, including dimensions, accessories, and specifications, see DF-G1 Expert Dual Display Fiber Amplifier Installation Instructions Mounting Instructions Mount on a DIN Rail 1. Hook the DIN rail clip on the bottom of the DF-G1 over the edge of the DIN rail (1). 2. Push the DF-G1 up on the DIN rail (1). 3. Pivot the DF-G1 onto the DIN rail, pressing until it snaps into place (2). Mount to the Accessory Bracket 1. Position the DF-G1 in the SA-DIN-BRACKET. 2. Insert the supplied M3 screws. 3. Tighten the screws. Remove from a DIN rail 1. Push the DF-G1 up on the DIN rail (1). 2. Pivot the DF-G1 away from the DIN rail and remove it (2). Installing the Fibers Move forward Follow these steps to install glass or plastic fibers. to release the fibers 1. Open the dust cover. Fiber Clamp 2. Move the fiber clamp forward to unlock it. 3. Insert the fiber(s) into the fiber port(s) until they Fiber Receiver stop. Port 4. Move the fiber clamp backward to lock the fiber(s). Fiber Emitter Port 5. Close the dust cover. Fiber Adapters NOTE: If a thin fiber with less than 2.2 mm outer diameter is used, install the fiber adapter provided with the fiber assembly to ensure a reliable fit in the fiber holder. Banner includes the adapters with all fiber assemblies. 2 www.bannerengineering.com - Tel: +1-763-544-3164 P/N 161275 Rev. D