2912510-01 Bel Fuse

Ferrule Data Chart for Bel-Stewart Ferrule Hand Tool Cable Ferrule Crimp Inserts Ferrule Hand Tool Locator Plate Complete Ass y. Dia. Ram Stationary Part Number Part Number Part Number Part Number .005 Insert p/n Insert p/n .125 2912517-01 2912501-01 .135 2912515-01 2912516-01 2912518-01 2912502-01 .145 2912519-01 2912503-01 F-210-205 .155 2912522-01 2912504-01 2912520-01 2912521-01 .165 2912523-01 2912505-01 .175 2912524-01 2912506-01 .185 2912527-01 2912507-01 2912525-01 2912526-01 .195 2912528-01 2912508-01 2940211-01 .205 F-235-205-L 2912529-01 2912509-01 .215 2912532-01 2912510-01 .225 2912530-01 2912531-01 2912533-01 2912511-01 .235 2912534-01 2912512-01 .245 F-270-205 2912537-01 2912513-01 2912535-01 2912536-01 .255 2912538-01 2912514-01 .255 F-270-205 2912535-01 2912536-01 2912540-01* 2912539-01 .265 F-300-275 2912582-01 2912583-01 2912584-01 2912585-01 NOTE: 1. If cable diameter falls in between sizes shown, round up to next .005 increment. 2. ( * ) at part 2912540-01 = 4mm hex nut no Bel-Stewart Connector Locator Plate needed. Ferrule Hand Tool Instructions P/N 2940211-01 Manual 290005 Rev. A2 Bel-Stewart Connector 11118 Susquehanna Trail South Glen Rock, PA 17327-9199 (717) 235-7512 ASSEMBLY INSTRUCTIONS Stationary Locator Plate Ram Crimp Insert 29125xx-01 Insert 29125xx-01 (See chart on 29125xx-01 A (See chart on back page) (See chart on back page) back page) B 1 2 3 This tool incorporates an eccentric axle and an adjustment wheel to adjust and re- calibrate to ensure correct crimp performance. Should adjustment be necessary, the following procedure should be followed: 1. Loosen and remove the Combination Head screw (A). 4 5 2. Using a screw driver, turn the numbered adjustment wheel to the next higher/lower number (B). 1. Position Stationary Crimp Insert as shown. 3. Re-install the Combination Head 2. Install Insert with screw. Use 2.5mm Allen wrench. Screw and tighten. 3. Position Ram Crimp Insert as shown. 4. Place Insert on hand tool label side & position Locator Plate on opposite side. 5. Install Insert & Plate with screw. Use 2.5mm Allen wrench.