HCPL-0500 Broadcom

6N135/6, HCNW135/6 HCPL-2502/0500/0501 Single Channel, High Speed Optocouplers Data Sheet Lead (Pb) Free RoHS 6 fully compliant RoHS 6 fully compliant options available -xxxE denotes a lead-free product Description Features These diode-transistor optoc ouplers use an insula ting High speed: 1 Mb/s layer between a LED and an integrated photodetector to TTL compatible provide electr ical insu lation between input and out put. Available in 8-Pin DIP, SO-8, widebody packages Separate connections for the photodiode bias and out- put-transistor collector increase the speed up to a hun- Open collector output dred times that of a conventional phototransistor coupler Safety approval by reducing the base -collector capacitance. UL Recognized 3750 V for 1 minute (5000 V rms rms for 1 minute for HCNW and Option 020 devices) These single channel optocouplers are available in per UL1577 8-Pin DIP, SO -8 and Widebody package configurations. CSA Approved The 6N135, HCPL-0500, and HCNW135 are for use in TTL/ IEC/EN/DIN EN 60747-5-5 Approved CMOS, TTL/LSTTL or wide bandwidth analog applications. V = 567 V peak for SO-8 devices IORM Current transfer ratio (CTR) for these devices is 7% mini- V = 630 V peak for DIP 300 mil devices IORM mum at I = 16 mA. F V = 1414 V peak for DIP 400 mil (widebody) IORM devices The 6N136, HCPL-2502, HCPL-0501, and HCNW136 are designed for high speed TTL/TTL applications. A standard Dual channel version available (253X/053X/0534) 16 mA TTL sink current through the input LED will pro- Applications vide enough output current for 1 TTL load and a 5.6 k pull-up resistor. CTR for these devices is 19% minimum at High voltage insulation I = 16 mA. F Video signal isolation Functional Diagram Line receivers Feedback element in switched mode power supplies 8 NC 1 V High speed logic ground isolation CC TTL/TTL, TTL/CMOS, TTL/LSTTL TRUTH TABLE (POSITIVE LOGIC) 2 7 ANODE V B Replaces pulse transformers LED V O Replaces slow phototransistor isolators ON LOW 6 CATHODE 3 V O OFF HIGH Analog signal ground isolation NC 4 5 GND A 0.1 F bypass capacitor must be connected between pins 5 and 8. CAUTION: It is advised that normal static precautions be taken in handling and assembly of this component to prevent damage and/or degradation which may be induced by ESD.Schematic I CC 8 V CC I F 2 ANODE + V F I O 6 - V O CATHODE 3 5 SHIELD GND I B 7 V B Selection Guide Minimum CMR 8-Pin DIP Small-Outline Widebody (300 Mil) SO-8 (400 Mil) Current Single Dual Single Dual Single dV/dt V Transfer Channel Channel Channel Channel Channel CM (V/s) (V) Ratio (%) Package Package* Package Package* Package 1,000 10 7 6N135 HCPL-2530 HCPL-0500 HCPL-0530 HCNW135 19 6N136 HCPL-2531 HCPL-0501 HCPL-0531 HCNW136 15 HCPL-2502 *Technical data for these products are on separate Avago publications. 2