CW7270 Chemtronics

CHEMTRONICS Technical Data Sheet CW7270 CircuitWorks Silicone Free Heat Sink Grease TYPICAL PRODUCT DATA AND PRODUCT DESCRIPTION PHYSICAL PROPERTIES CircuitWorks Silicone Free Heat Sink Grease facilitates heat transfer away from Color White electrical/electronic components and into Specific Gravity 25 C (77F) 2.4 heat sinks. This silicone-free compound Usable Temperature 5F (-15C) to shows no creep or migration over a wide Range 392F (200C) temperature range. Thickened with a Dielectric Strength, volts/mil 500 proprietary thermally conductive zinc oxide ceramic, the CircuitWorks Silicone Free Dielectric Constant 100 Hz 4.4 Heat Sink Grease creates an effective heat Dissipation Factor 100 Hz 0.005 sink interface in electrical/electronic 14 Volume Resistivity, ohm-cm 1 x 10 equipment. Arc Resistance, seconds 120 Thermal Conductivity, Exceeds MIL-C-47113 for thermal 2 -3 Cal-cm/sec-cm -C 1.7 x 10 conductivity 2 BTU-in/hr-ft -F 4.92 Noncorrosive W/mK 0.71 High dielectric strength Low migration Shelflife 5 years RoHS Compliant Stable from -15 C to 200 C Nonflammable COMPATIBILITY CircuitWorks Silicone Free Heat Sink TYPICAL APPLICATIONS Grease is generally compatible with most CircuitWorks Silicone Free Heat Sink materials used in printed circuit board Grease may be used for electronics fabrication. applications including: Effective Thermal Coupler for any Heat Sink Device Nonflammable Protective Coating High Voltage Corona Protection Excellent for Improving Readings on Contact Type Thermocouples Ideal for Silicone Sensitive Environments AVAILABILITY Material Compatibility CW7270 8 gm / 0.28 oz syringe Ceramic Good Clean Metals Good ENVIRONMENTAL IMPACT DATA Glass Good ODP None VOC None Silicone Resins Good HCFC None HFC None Painted Surfaces Good Ozone depletion potential (ODP) is determined in accordance with the Plastic Surfaces Good Montreal Protocol and U.S. Clean Air Act of 1990. Vulcanized Silicone Rubber Good Hydrochlorofluorocarbons (HCFCs) are regulated under the Montreal Protocol as Class II ozone depleting substances. Volatile Organic Compound (VOC) information is calculated on a weight basis using the VOC definition of California Air Resources Board (CARB) Consumer Product Regulations, USAGE INSTRUCTIONS South Coast Air Quality Management District (SCAQMD) Rule 102 and the For industrial use only. Federal definition published in 40 CFR 51.100(s). Hydrofluorocarbons (HFCs) are not currently regulated. Read MSDS carefully prior to use. NOTE: Application: This information is believed to be accurate. It is Apply CircuitWorks Silicone Free Heat intended for professional end users having the skills Sink Grease directly to surface or use the to evaluate and use the data properly. application tip. Remove cap from syringe CHEMTRONICS does not guarantee the accuracy and gently depress the plunger. Spread the of the data and assumes no liability in connection material in a thin layer on all mounting and with damages incurred while using it. threaded surfaces of the device and the CHEMTRONICS chassis. 8125 COBB CENTER DRIVE KENNESAW, GA 30152 Clean-Up: Wipe away excess material 1-770-424-4888 REV. C (08/13) using a Chemtronics ControlWipes and thoroughly clean the surface using Chemtronics , Electro-Wash and CircuitWorks are Chemtronics Electro-Wash PX. registered trademarks of Chemtronics. All rights reserved. ControlWipes is a trademark of Chemtronics. All rights reserved. TECHNICAL & APPLICATION ASSISTANCE DISTRIBUTED BY: Chemtronics provides a technical hotline to answer your technical and application related questions. The toll free number is: 1-800-TECH-401.