SIP05-12S05A

V19 SIPSMT05-12 SERIES 5 AMP POL CONVERTERS FEATURES * Non-Isolated POL Converter * SIP/SMT Package * Output Current 5AMP * Input Voltage Range 8.3 14VDC * Output Voltage Range 0.75-5VDC * High Efficiency to 92% * Over Temperature Protection * Continuous Short Circuit Protection * Remote On/Off Control * UL/C-UL60950 Certified * Safety Meets IEC/EN/UL 62368-1 INPUT CURRENT Efficiency MODEL INPUT OUTPUT OUTPUT NUMBER VOLTAGE VOLTAGE CURRENT NO LOAD FULL LOAD (%) 0.75VDC 5A 20mA 428mA 73 1.2VDC 5A 25mA 625mA 80 1.5VDC 5A 25mA 762mA 82 SIP05-12S05A 1.8VDC 5A 30mA 893mA 84 8.3 14VDC 2.0VDC 5A 30mA 980mA 85 SMT05-12S05A 2.5VDC 5A 35mA 1197mA 87 3.3VDC 5A 45mA 1545mA 89 5.0VDC 5A 50mA 2264mA 92 NOTE: Nominal Input Voltage 12VDC L1 Q1 Vo,set (V) Rtrim (K) +VIN +VO 0.75 Open 1.2 22.33 1.5 13.0 Q2 D1 C1 C2 1.8 9.0 2.0 7.4 2.5 5.0 3.3 3.12 5.0 1.47 COM COM Table 1. External Resistor Values R1 for programming output voltage PWM IC Rt ON/OFF TRIM ERR AMP R2 Figure 1. Simplified Schematic 1 V19 SPECIFICATIONS All Specifications Typical at Nominal Line, Full Load, and 25 Unless Otherwise Noted INPUT SPECIFICATIONS: GENERAL SPECIFICATIONS: Input Voltage Range ........... 12V ....... 8.3 14V Efficiency ...................................................... See Table Under Voltage Lock-out . power up ... 8.0V typ. Isolation Voltage ............................................. Non-Isolation power down ... 7.9V typ. Switching Frequency ................................................... 300KHz typ. Over Temperature Protection .. 120 typ. Input Filter Type ...... Capacitive Positive Remote on/off Control: Operating Ambient Temperature Range ............ -40 to +85 Module On ... Open Circuit or = Vin Power Derating Curve ... See Figure2, 3 Module Off ... 0 to <0.4Vdc Storage Temperature Range .......................... -55 to +125 MTBF . MIL-HDBK-217F, GB, 25, Full Load 1.5Mhrs typ. OUTPUT SPECIFICATIONS: Voltage Accuracy ......... 1.5% max. Dimensions: SIP Package: 0.90x0.400x0.22 inches (22.9x10.16x5.6mm) Transient Response: 50% Step Load Change .................... <200us SMT Package: 0.80x0.450x0.24 inches (20.3x11.43x6.09 mm) Ripple and Noise, 20MHz BW (note3) .. 20mVrms, 50mVpk-pk max. Structure .... Non-Potted with Open Frame Type Weight .... 2.3g Vo=5Vdc . 45mVrms, 75mVpk-pk max. Temperature Coefficient .......................... 0.03%/ max. NOTE: Short Circuit Protection ............................. Continuous 1. Measured from high line to low line, Vo,set=1.8Vdc. Line Regulation (note1) ............ 0.2% max. 2. Measured from full load to zero load, Vo,set=3.3Vdc. Load Regulation (note2) .............. 0.5% max. 3. The output noise is measured with 10uF tantalum capacitor and 1uF Capacitive Load Low ESR ........ 3000uF max. ceramic capacitor across output. External Trim Adj. Range (See Table1) . Vo=0.75 5.0Vdc 4. The input terminal recommend to parallel with 100uF capacitor Start up Time ...... 7ms typ. ESR<100M to reduce the input ripple voltage. 5. Suffix N to the model number with negative logic remote on/off Model on ... Open Circuit or 0 to < 0.4Vdc Module off .... >+2.8VDC to Vin Dimensions: SIP Packages SMT Packages BOTTOM VIEW OF BOARD 0.80 0.90(22.9) 0.22(5.6)Max. PIN CONNECTION (20.3) 0.24 (6.09) max. 0.190 Pin FUNCTION 0.160 0.160 0.180 0.065 (4.06) (4.83) (4.06) (4.57) (1.65) +Output 1 0.400(10.16) 1 2 3 4 5 2 Trim TRIM VOUT GND 0.35 0.340 3 Common (8.9) 0.14(3.6) (8.64) 4 +V Input 0.450 0.025(0.64) 0.100(2.54) (11.43) 0.025(0.64) 0.200(5.08) 5 On/Off VIN ON/OFF 0.700(17.78) 0.19(4.7) 0.800(20.32) (1.5) 0.06 1.1mm PLATED THROUGH HOLE 0.062 Surface Mount Contact 5 Places (1.57) 0.090 1.6mm PAD SIZE (1.3) 0.05 (2.29) All Dimmension In Inches(mm) LAYOUT PATTERN 0.24(6.1) Dimensions are in Inches (millimeters) 0.20(5.1) TOP VIEW Tolerance : Tolerances :x.xx 0.02in.( x.x 0.5mm) , unless otherwise noted .XX= 0.02 ( 0.5 ) x.xxx 0.010in. ( x.xx 0.25mm) .XXX= 0.010 ( 0.25 ) SIP05-12S05A (Vo=3.3V) Derating Curve SMT05-12S05A (Vo=3.3V) Derating Curve 6.00 6.00 5.00 5.00 4.00 4.00 3.00 3.00 0LFM 0LFM 2.00 2.00 100LFM 100LFM 200LFM 200LFM 1.00 1.00 0.00 0.00 20 30 40 50 60 70 80 90 100 20 30 40 50 60 70 80 90 100 o o Ambient Temperature( C) Ambient Temperature( C) Figure2. Typical Power De-rating for 12V IN 3.3Vout Figure3. Typical Power De-rating for 12V IN 3.3Vout 2 Output Current(A) Output Current(A)