515-1023F Dialight

3mm Square TM Optopipe Optical Light Pipe, Quad High 515-1023-803 3.20 .76 .126 Recommended .030 REF. LIGHTSHIELDS MicroLED SMT LEDs 4.95 2 PLCS .195 3.18 .125 4.95 .195 for use with 515-1023-803 21.59 .850 2 4.95 .195 5.16 3.53 PART NO. COLOR PAGE 4.45 .203 .139 .175 4.31 597-3001-1xx Red 1-19 4.45 NOTE: .170 .175 C.L. of LED 4.45 .175 6.02 597-3111-1xx AlGaAs Red 1-19 5.31 .237 .209 19.69 .775 .116 DIA TYP. 28.75 597-3211-1xx Orange 1-19 (2) PLACES 8.23 1.132 .324 597-3301-1xx Green 1-19 13.34 .525 9.07 597-3401-1xx Yellow 1-19 Direction .357 4.45 of Light .175 597-7701-1xx Red/Green 1-20 1.24 .99 .049 .039 597-7721-1xx Yellow/Green 1-20 2.01 .079 NOTE: designed for 597-7731-1xx Red/Yellow 1-20 .51 .99 post-reflow .020 .039 4.12 .113 .002 .162 PC board insertion. RECOMMENDED PIN HOLES AND SOLDER PAD LAYOUT FOR SUGGESTED MicroLED LEDs Dimensions in mm inches COMPONENT SIDE OF PRINTED CIRCUIT BOARD Features LED Data For absolute maximum ratings and other High transmissivity polycarbonate material electrical and optical data on the recommended UL94V-0 compliance LEDs, refer to LED data sheets. ESD protection (circuit isolation from front panel) Wide viewing angle Operating/Storage Temperature Arrays reduce insertion costs 30C to +100C Allows quad level SMT indicators Secures to PCB by press-fit Dialight Optopipe Light Pipe Description This Optopipe has a relatively low vertical height considering the number of light pipe elements. The elements square emitting surfaces are vertically spaced 0.203 from the PCB to the first element, and then 0.195 between each of the other elements. This Optopipe is held in place by 2 press-fit pins on the bottom of the device. The wide base offers added stability to the installed part. The light pipe is not attached to the panel at any point, but protrudes through holes in the panel. This Optopipe was specifically designed to accept Dialights 597 Series Type 1210 LEDs. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index. Dialight can provide custom Optopipe solutions for your applications. Dialight Corporation 1501 Route 34 South Farmingdale, NJ 07727 TEL: (732) 919-3119 FAX: (732) 751-5778 www.dialight.co m 2-51 NEWX-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for LED Light Pipes category: Click to view products by Dialight manufacturer: Other Similar products are found below : 1367627-1 SLP3-300-450-F SLP3-400-450-R LPA-C011301S-23 LPA-C011301S-6 LPF-C011306S FLP25-1.95 VLP-640-F LPA- C011301S-5.4 LPA-C041301S-2 LPA-R051171S-12 LPA-S011331S 515-1027-803F 515-1217F SLP3-150-300-R SLP3-500-450-R 515- 1064-810F FLPV-SG BDL-1187 7511A41 7511A87-500 FLPV-SBC 5151064802F 5151-192-0055-0DF LPF-R011340S 515-1166-801F FLPF-6.0 SLP3-350-200-F PM4-C1522-3.70 LC-11.25 CLP-1214 515-1064-808F FLX3 05 515-1192-0025-0DF 515-1192-80-3DF PBLP- 1001-1 LC2-4.1 LPC062CTP LSS024CTP LPC088CTP SLP3-150-300-F 2202312 515-1302-0500F RLP1-200-800 RLP1-400-500 LPA- C011301S-15 2202311 SLP3-150-450-R 7511A53 1270.1003