EA SER404-HNLEK Display Visions

THE SERIALS Issue 7.2019 DOTMATRIX DISPLAYS WITH RS-232 EA SER162-92NLED with snap in housing Accessory: cable EA KV24-9B length: 1,50 m FEATURES * 32 DIFFERENT SIZES OF DISPLAYS AVAILABLE (1x8 UP TO 16x40) 1) * SUPPLY VOLTAGE +5V OR OPTIONAL 9..35V * INCL. LED-ILLUMINATION SWITCHABLE BY MEANS OF SOFTWARE * 25 DISPLAYS WITH YELLOW/GREEN LED-BACKLIGHT * 7 DISPLAYS WITH LOW POWER WHITE LED-BACKLIGHT * 3 DISPLAYS 1X8, 2X16 AND 4X20 WITH SNAP IN HOUSING * HIGH CONTRAST SUPERTWIST LCD 2) * INCL. FRONTAL BEZEL WITH ANTIGLARE GLASS * AUTOMATIC LINE MANAGEMENT * CR / LF / SCROLL / CURSOR POSITIONING * BAUDRATE SETTING BY JUMPER: 300, 1200, 2400 OR 9600 BAUD * POTI FOR CONTRAST ADJUSTMENT ON BOARD * MULTIPLE DISPLAYS ON SINGLE RS-232C OPTIONS 1) * SUPPLY +9..35V= INSTEAD OF +5V= EA OPT-9/35V 1) * RS-422 INTERFACE INSTEAD OF RS-232 (STANDARD) EA OPT-RS422 1) * DIP-SWITCH FOR ADDRESS INSTEAD OF SOLDERBRIDGE EA OPT-DIP6 ACCESSORIES * CABLE WITH 9-PIN D-SUB FEMALE PLUG FOR PC EA KV24-9B 1) not available with SER308, SER408, SER3016 and SER4016 2) not available for all displays please refer to the table at page 20 The SerialsTHE SERIALS GENERAL The SerialsThe SerialsThe Serials represents a complete LCD-Dotmatrix familiy with The SerialsThe Serials input circuit and frontal bezel. These LCD-modules also includes a RS-232 interface (or optional RS-422). The mounting is done through holes of the LCD-module, the data connection is made to a standard RS-232C/RS-422 interface. Transfer rate can be set by jumper on 300, 1200, 2400 or 9600 Baud. All cursor controls (line feed etc.) are performed automatically. All displays scheme feature LED-backlight illumination. Matching frontal bezel with antiglare glass is included also. POWER SUPPLY / CONTRAST ADJUSTMENT Supply voltage is +5V, current consumption depends on type of display and its illumination (100-800 mA, see table on page 20). The Serials can be connected to power either by screw terminals or with RS-232 connector. Display contrast is adjustable by potentiometer. important: It is imperative that the polarity is correct. Even very brief polarity reversal can damage the entire operating unit immediately and irreparably. 9..35V Versorgung bei Displays im Snap-In MULTIPLE DISPLAYS ON A SINGLE RS-232C A single RS-232C can operate a number of displays. For that an individual adress must be assigned to each display. CommandsSelect/Deselec will target each individual display. Adresseinstellung per Ltbrcken Adresseinstellung ber DIP-Schalter Adresseinstellung bei Displays im Snap-In 1) not available with SER308, SER408, SER3016 and SER4016 2) not available with SER082-C, SER204-4, SER242-B, SER3016 and SER4016 Page 2 Printing and typographical errors reserved. ELECTRONIC ASSEMBLY reserves the right to change specifications without prior notice.