DLP-uCF917
LEAD-FREE
PIC16F917 TARGET BOARD
PIC16F917 TARGET BOARD
1.0 INTRODUCTION
The DLP-uCF917 Target Board is designed to easily connect to the DLP-FLASH2 Device
Programmer/Debugger and provide the design engineer with a low-cost hardware platform for
developing and testing applications for the PIC16F917 microcontroller.
(Refer to the schematic at the end of this datasheet for additional details.)
2.0 SPECIFICATIONS
Program Memory: 8K x 14
2.0-5.5V Operation**
RAM Size: 352 x 8
31 I/O (8x10b Analog)
EEPROM Size: 256 x 8
LED Indicator
Size: 1.92 x 0.89 Inches
**Note: If this target board is operated at a voltage other than 5.0 volts via a user-supplied power
source, then the TPWR jumper must be removed on the DLP-FLASH2 Programmer.
3.0 OSCILLATOR OPTIONS
The PIC16F917 has an internal, factory-calibrated (1%) oscillator with eight user-selectable
frequencies from 31 kHz to 8 MHz. Refer to the datasheet for the PIC16F917 for additional details.
A user-supplied crystal and associated capacitors can also be added if a specific operating frequency
is required.
Rev. 1.1 (September 2007) 1 DLP Design, Inc. 4.0 PROGRAMMER/DEBUGGER INTERFACE
The DLP-FLASH2 Programmer/Debugger utilizes a 6-pin, 2mm female header for connection to the
target device. The following shows the pinout for the programming interface connectors:
Pin 1
Pin 2
Target Header
DLP-FLASH2
Pin # Description Alternate Name
1 PGM B3
2 PGC B6
3 PGD B7
4 Ground
5 Target Power TVDD
6 MCLR Vpp
5.0 DISCLAIMER
Neither the whole nor any part of the information contained herein or the product described in this
datasheet may be adapted or reproduced in any material or electronic form without the prior written
consent of the copyright holder.
This product and its documentation are supplied on an as-is basis, and no warranty as to their
suitability for any particular purpose is either made or implied. DLP Design will not accept any claim
for damages whatsoever arising as a result of use or failure of this product. Your statutory rights are
not affected.
This product or any variant of it is not intended for use in any medical appliance, device or system in
which the failure of the product might reasonably be expected to result in personal injury.
This document provides preliminary information that may be subject to change without notice.
6.0 CONTACT INFORMATION
DLP Design, Inc.
1605 Roma Lane
Allen, TX 75013
Phone: 469-964-8027
Fax: 415-901-4859
Email: support@dlpdesign.com
Internet: