Using a third common contact pin halves the Principal Electrical and Performance Data PCB area to maximise code setting on at 20C 70% R.H. crowded PCB s. They are also used widely for Contact Ratings: Non Switching: 100Vac, 5A Switching: 1 V to two state, pull up / pull down resistor setting. 100V, 1A to 1A up to 10VA. Initial Contact Resistance: (at l0mV, l0mA max.) Typical: 10m . Large numerals and EIA colour coded Max. 20m . sliders. Insulation Resistance: (at 500Vdc min.) l0,000M . Base and tape seal for flow soldering and Life: For the first 1000 closures the standard deviation of the solvent / aqueous washing. change in resistance from the mean is usually less than 1 m . Mechanical wear out of the sliding actuator is usually observed after 10,000 operations. 1m hard gold plated wiping contact gives high reliability. Dielectric Strength: 1 minute: 500Vrms 50Hz. Capacitance Between Open Contacts: < 1 pf at 1 KHz. If you have a volume requirement for a product variant not shown, please contact us. Temperature: operating range for continuous electrical use and manual operation is restricted to -55C to +100C for standard products. Humidity: BS 2011 Test Ca: 56 days. Spectra C CHANGEOVER TRIPLE IN LINE s.p.d.t SCS 023 series Bump: BS 2011 Test Eb: No contact interruptions > 1s during Part Nos Length Number of 4000 bumps at 390m/s (40g). SCS-plus mm s.p.d.t suffix max 1 1-023 4.0 Acceleration: BS 2011 Test Ga: No contact interruptions > 1s 10.5 max during test at 980 m/s (100g). 2 2-023 6.7 length 4 4-023 11.8 Vibration: BS 2011 Test Fc: 10 to 2000Hz. No contact 6 6-023 16.8 9 (max) interruptions > 1 s during test at 147 m/s (15g) or l.Omm 8 8-023 21.9 0.40 x 3.0- 5.0 displacement amplitude. 0.55 10 10-023 27.0 2.54 2.54 pitch 7.62 Shock: BS 2011 Test Ea: 980 m/s (100g). No contact interruptions > 1 s during test. Spectra C GANGED CHANGEOVER TRIPLE IN LINE d.p.d.t Soldering: solderability: < 2 seconds to wet at 235C as per IEC SCS G-023 series 68 and BS 2011 Test T. solder bath method. Part Nos Length Number of SCS-plus mm Resistance to soldering heat as per IEC 68 and BS 2011 10 d.p.d.t suffix max seconds satisfactory at 260C when mounted on l.5mm PCB. 1 1G2-023 4.0 10.5 max length 2 2G2-023 6.7 Please note: BS 2011 is now superseded by BS EN 60068. 3 3G2-023 11.8 9 (max) 4 4G2-023 16.8 0.40 x 3.0- 5.0 5 5G2-023 21.9 0.55 2.54 2.54 pitch 7.62 This leaflet is believed to contain the best information available at the time of printing, but is subject to change without notice. Performance figures, where quoted, are Engelking Elektronik GmbH Albstrasse 16 actually estimates based on our experience or that of our customers or statutory authorities. In common with all components reliability varies with many factors, and D-78609 Tuningen users are invited to contact us in appropriate cases so that where relevant information is available it may be considered by the user. All supplies are subject to the Company s Tel: +49 (0) 7464 9865 0 Fax: +49 (0) 7464 9865 71 standard conditions of sale which are available on request. sales itw-switches.de www.itw-switches.de Spectra C - 023 styleX-ON Electronics Largest Supplier of Electrical and Electronic Components Click to view similar products for erg manufacturer: Other Similar products are found below : BE-8610 BE-8705 SDC-4-023 4239 BE-7806 BE-8702 BE-8706 BE-8160 BE-8801 BE-8910 BE-7808 BE-8620 BE-8350 BE-8602 BE- 7804 BE-8907 RX8141 4131 2101G-160 2427G160 BE-8802 BE-8601 BE-8908 BE-8040 BE-7807 9070 020741E DS16C1-8 DS16C4- 2 ERG16-412/2 SDS-4-023 SDS-10-014 ERG10-412/6 SDD-2-023 ERG10-412/2 JSA4-1-G0