SiPM Module The SiPM Module integrates a stable voltage supply, signal amplification, interfaces and the SiPM detector in a compact plug and play unit. Included software allows op- timization of the operating point of the detector to the re- spective application by the precise and individual setting and storage of the supply voltage. The new SiPM Module is used for test set-ups in research and development and is ideally suited for photon counting applications. Features Applications Certificates Light detection from 350 to 900 nm Ultra-low-level light measurement RoHS compliant (2011/65/EU) Ultra compact Single photon counting Very light weight Scientific applications Different SiPM sizes, 1x1, 3x3, 4x4 mm Scintillator readout Voltage supply with low ripple Gamma counting Control software Setup board for voltage setting Non cooled, analog output Built-in SiPM optimized for NUV (420nm) or RGB (550nm) light detection Optional version with LYSO scintillation crystal Version 26-03-18 Subject to change without notice www.first-sensor.com contact first-sensor.com Page 1/6 PRELIMINARYSiPM Module (1) Absolute maximum ratings Parameter Min. Max. Unit Operating temperature (T ) -10 +40 C op Storage temperature (T ) -20 +60 C S Supply voltage (V ) typ. 5 V S Output voltage (V ) typ. 1.2 V 50 out (1) Electro-optical characteristics NUV type RGB type Parameter Min. Typ. Max. Min. Typ. Max. Unit Active area 11, 3x3, 4x4 11, 3x3, 4x4 mm Recharge time constant 70 50 ns Peak responsivity 420 550 nm Breakdown voltage (BV) 24 26 28 25 27 29 V Recommended overvoltage range (OV) 2 6 2 4 V 2 Dark count rate <50 2 V OV, <100 6 V OV <100 2 V OV, <200 4 V OV kHz/mm 6 6 Gain 3.610 2.710 Characteristics for module Parameter Min. Typ. Max. Unit Bandwidth 25 MHz Voltage ripple 5 mV Specification notes (1) For further technical information, see SiPM datasheets. Version 26-03-18 Subject to change without notice www.first-sensor.com contact first-sensor.com Page 2/6 PRELIMINARY