30KPA33CA

Transient Voltage Suppression Diodes Axial Leaded 30000W > 30KPA series Pb e3 RoHS 30KPA Series Descriptios Uni-directional The 30KPA Series is designed specifically to protect sensitive electronic equipment from voltage transients induced by lightning and other transient voltage events. Bi-directional Features 30000W peak pulse Low incremental surge capability at 10/1000s resistance waveform, repetition rate Typical I less than 2A R (duty cycles):0.01% when V min>73V BR Glass passivated chip High temperature Agency Approvals junction in P600 package to reflow soldering Fast response time: guaranteed: 260C/40sec AGENCY AGENCY FILE NUMBER typically less than 1.0ps / 0.375, (9.5mm) lead from 0 Volts to BV min length, 5 lbs., (2.3kg) E230531 tension Excellent clamping capability V @ T = V @25C BR J BR x (1+T x (T - 25)) T ypical failure mode is J Maximum Ratings and Thermal Characteristics (T:Temperature short from over-specified O (T =25 C unless otherwise noted) A Coefficient, typical value voltage or current is 0.1%) Whisk er test is conducted Parameter Symbol Value Unit Plastic package is based on JEDEC Peak Pulse Power Dissipation by ammabilitfl y rated V-0 per JESD201A per its table 4a 10/1000s Test Waveform (Fig.2) P 30000 W PPM Underwriters Laboratories and 4c (Note 1) Matte tin leadfree plated IEC-61000-4-2 ESD Steady State Power Dissipation on P 8.0 W D 30kV(Air), 30kV (Contact) Halogen free and RoHS Infinite Heat Sink at T =75C L compliant Peak Forward Surge Current, 8.3ms ESD protection of data Single Half Sine Wave Unidirectional I 400 A lines in accordance with Pb-free E3 means 2nd FSM Only (Note 2) IEC 61000-4-2 level interconnect is Operating Junction and Storage Pb-free and the terminal T , T -55 to 175 C EFT protection of dat a J STG Temperature Range finish material is tin(Sn) lines in accordance with Typical Thermal Resistance (IPC/JEDEC J-STD- IEC 61000-4-4 R 8.0 C/W JL Junction to Lead 609A.01) Typical Thermal Resistance R 40 C/W JA Junction to Ambient Applications Notes: O 1. Non-repetitive current pulse , per Fig. 4 and derated above T (initial) =25 C per Fig. 3. TVS devices are ideal for the protection of I/O interfaces, J 2. Measured on 8.3ms single half sine wave or equivalent square wave, duty cycle=4 per V bus and other vulnerable circuits used in telecom, CC minute maximum. computer, industrial and consumer electronic applications. Functional Diagram Additional Infomarion Datasheet Samples Resources Bi-directional Cathode Anode Uni-directional 2016 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 09/27/16Transient Voltage Suppression Diodes Axial Leaded 30000W > 30KPA series Electrical Characteristics (T =25C unless otherwise noted) A Maximum Maximum Breakdown Test Reverse Maximum Agency Reverse Part Part Clamping Voltage V Current Stand off BR Peak Approval Leakage Number Number Voltage (Volts) @ I I Voltage V Pulse Current T T R I @V (Uni) (Bi) V @ I R R C PP (Volts) I (A) (mA) pp MIN MAX (V) ( A) 30KPA28CA 28 31.28 34.41 50 606.0 5000 50.0 30KPA28A X 30KPA30A 30KPA30CA 30 33.51 36.86 50 548.9 5000 55.2 X 30KPA33CA 33 36.90 40.59 50 517.9 5000 58.5 30KPA33A X 30KPA36CA 36 40.20 44.22 50 490.3 5000 61.8 30KPA36A X 30KPA39CA 39 43.60 47.96 20 450.9 2000 67.2 30KPA39A X 30KPA42CA 42 46.90 51.59 10 420.8 1000 72.0 30KPA42A X 30KPA43A 30KPA43CA 43 48.00 52.80 10 415.1 1000 73.0 X 30KPA45CA 45 50.30 55.33 5 391.5 250 77.4 30KPA45A X 30KPA48A 30KPA48CA 48 53.60 58.96 5 371.3 150 81.6 X 30KPA51CA 51 57.00 62.70 5 350.7 50 86.4 30KPA51A X 30KPA54A 30KPA54CA 54 60.30 66.33 5 331.5 20 91.4 X 30KPA58CA 58 64.80 71.28 5 327.9 20 92.4 30KPA58A X 30KPA60A 30KPA60CA 60 67.00 73.70 5 297.1 15 102.0 X 30KPA64CA 64 71.50 78.65 5 291.3 10 104.0 30KPA64A X 30KPA66A 30KPA66CA 66 73.70 81.07 5 283.2 2 107.0 X 30KPA70CA 70 78.20 86.02 5 278.0 2 109.0 30KPA70A X 30KPA71A 30KPA71CA 71 79.30 87.23 5 271.7 2 111.5 X 30KPA72CA 72 80.40 88.44 5 265.8 2 114.0 30KPA72A X 30KPA75CA 75 83.80 92.18 5 253.8 2 119.4 30KPA75A X 30KPA78CA 78 87.10 95.81 5 234.9 2 129.0 30KPA78A X 30KPA84A 30KPA84CA 84 93.80 103.18 5 217.7 2 139.2 X 30KPA90CA 90 100.50 110.55 5 207.0 2 146.4 30KPA90A X 30KPA96A 30KPA96CA 96 107.20 117.92 5 194.2 2 156.0 X 30KPA102CA 102 113.90 125.29 5 183.0 2 165.6 30KPA102A X 30KPA108A 30KPA108CA 108 120.60 132.66 5 172.9 2 175.2 X 30KPA120CA 120 134.00 147.40 5 155.9 2 194.4 30KPA120A X 30KPA132A 30KPA132CA 132 147.40 162.14 5 142.3 2 213.0 X 30KPA144CA 144 160.80 176.88 5 135.8 2 223.2 30KPA144A X 30KPA150A 30KPA150CA 150 167.60 184.36 5 129.8 2 233.4 X 30KPA156CA 156 174.30 191.73 5 123.7 2 245.0 30KPA156A X 30KPA160CA 160 178.70 196.57 5 120.0 2 252.6 30KPA160A X 30KPA168A 30KPA168CA 168 187.70 206.47 5 111.2 2 272.4 X 30KPA170A 30KPA170CA 170 189.90 208.89 5 110.2 2 275.0 X 30KPA180CA 180 201.10 221.21 5 104.3 2 290.4 30KPA180A X 30KPA198A 30KPA198CA 198 221.20 243.32 5 94.7 2 319.8 X 30KPA216A 30KPA216CA 216 241.30 265.43 5 86.9 2 348.6 X 30KPA240CA 240 268.10 294.91 5 78.3 2 387.0 30KPA240A X 30KPA258A 30KPA258CA 258 288.20 317.02 5 72.8 2 416.4 X 30KPA260CA 260 290.40 319.44 5 72.8 2 416.0 30KPA260A X 30KPA270A 30KPA270CA 270 301.60 331.76 5 69.5 2 436.2 X 30KPA280CA 280 312.80 344.08 5 65.3 2 464.0 30KPA280A X 30KPA288A 30KPA288CA 288 321.70 353.87 5 64.5 2 469.9 X 30KPA300CA 300 334.00 367.40 5 62.0 2 484.0 30KPA300A X For bidirectional type having V of 60 volts and less, the I limit is double. RWM R For parts without A , the V is 10% and Vc is 5% higher than with A parts. BR 2016 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 09/27/16