CYUSB3ACC-005 Infineon

FMC INTERCONNECT BOARD CYUSB3ACC-005 TM 1. Connect the EZ-USB FX3 SuperSpeed Explorer (CYUSB3KIT-003) to the FMC Interconnect Board (CYUSB3ACC-005) 2. Plug the FMC Interconnect Board into the Xilinx FPGA board (The Xilinx FPGA board is not part of this kit) 3. Make sure that Jumper J5 on CYUSB3KIT-003 is open 4. Learn to use FX3 in applications involving Xilinx FPGA with the application TM note AN65974 - Designing with the EZ-USB FX3 Slave FIFO Interface available at FMC INTERCONNECT BOARD CYUSB3ACC-005 Note: Please take care when removing the accessory board from the SuperSpeed Explorer Kit board. The suggested removal method is shown in the picture above. Hold the accessory board and use a rocking motion to separate the boards safely For the latest information about this interconnect board and to download the hardware les, visit www.cypress.com/go/CYUSB3ACC-005 For the latest information about EZ-USB FX3 SuperSpeed Explorer Kit (CYUSB3KIT-003) and to download Kit Software and Hardware les, visit www.cypress.com/go/SuperSpeedExplorerKit 2014 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc. 001-92305 Rev**