10mm iDea Series Panels on Demand The iDea Series LED System offers a variety of quick convenient solutions for designing, installing, and modifying LED systems in field. Simply cut LED flex strips to length, add connectors, lay the LEDs along an aluminum channel, and snap your choice of covers in to place. Creating custom LED fixtures has never been easier than with the innovative iDea Series LED system from Inspired LED. Product Features: CSA listed (C22.2 No. 250.0-08), sleek , lightweight design Compatible with range of flexible LED colors & brightness levels Simple connectors allow flex to be cut & built to custom lengths Frosted white or clear lens covers Clip, screw, or adhesive mounting options Can be weatherproofed in-field with addition of GE Lifetime Rated Silicone To be installed in accordance with NEC, using Class 2 power supply only Step 1: Cut Select Inspired LED flex strips in the brightness level and color of your choosing, then cut to length on copper solder pads Mega Bright (240 ohm) 24V-MB240-XX best for subtle accent or task lighting Mega Bright (100 ohm) 24V-MB100-XX best value accent or task lighting Mega Bright (75 ohm) 24V-MB75-XX the very brightest task light Open connector locking cap and peel Identify polarity on LED strip. Polarity is marked Step 2: Connect adhesive liner from flexible LED strip. throughout the length of the flexible LED stip. Use Attach iDea series end- a red sharpie to mark polarity on connector. connectors to connect to wire Strip 18-22AWG cable and match polarity between Insert flexible LED strip into LED input LED connector and cable. channel of connector. Poke cable leads into wire holes of connector making sure the positive polarity matches the positive input hole of connector. Close locking cap until the snap of the connector is heard. The snapping sound Size: 0.49 x 0.64 x 0.18 indicates the locking cap has been properly Screw Terminal Size: Fits 18-22 AWG NOTE: Connectors are not assigned polarity. Polarity must be defined terminated. by user. Look throughout the length of the strip to identify polarity, it SKU : 3636 (single) 3683 (bag of 25) may not be indicated exactly at each cut point. Check termination by Compatible with Inspired LED 24V tugging on the cable leads and LED flex to insure tight connections. Flex Only Cable should be difficult to remove when properly terminated. inspiredled.com orders inspiredled.com (480) 941-4286 Assign polarity on flex-extender To connect LED flex strips end-to- Step 2: Connect (Part II) using a red pen end, begin by matching polarity Attach iDea series flex-extenders between joining LED strips to connect LED flex strips end to end Insert LED flex into either side of flex- Open locking caps on each side extender, matching polarity, then of flex-extender firmly snap each end shut, using pliers if needed Size: 0.82 x 0.5 x 0.18 Screw Terminal Size: Fits 18-22 AWG SKU : 3637 (single) 3684 (bag of 5) Compatible with Inspired LED 24V Flex Only Step 3: Panelize Create an on-demand fixture in just minutes using aluminum extrusion and snap-on lenses Aluminum Channel (6): 3606 Lay flex along aluminum channel with end connectors hanging over edge & cut to length Polycarbonate Covers (6): 3633 Snap cover over aluminum & end connectors, cut to length White 3633-W Clear 3633-C Mounting Clips/Screws (10/bag): 3687 Screw into desired location, then secure iDea series panel in place 265216 inspiredled.com orders inspiredled.com (480) 941-4286