WP7113SECK/J3 Kingbright

T-1 3/4 (5mm) SOLID STATE LAMP Part Number: WP7113SECK/J3 Hyper Red Features Description z Low power consumption. The Hyper Red device is based on light emitting diode chip z Popular T-1 3/4 diameter package. made from AlGaInP. z General purpose leads. z Reliable and rugged. z Long life - solid state reliability. z Available on tape and reel. z RoHS compliant. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.25(0.01 ) unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. SPEC NO: DSAM7945 REV NO: V.2A DATE: JUN/14/2013 PAGE: 1 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Y.Liu ERP: 1101032229 Selection Guide Iv (mcd) 2 Viewing 20mA Angle 1 Part No. Dice Lens Type Min. Typ. 21/2 6000 10000 WP7113SECK/J3 Hyper Red (AlGaInP) Water Clear 20 *3600 *6000 Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2. Luminous intensity/ luminous Flux: +/-15%. * Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Electrical / Optical Characteristics at TA=25C Symbol Parameter Device Typ. Max. Units Test Conditions peak Peak Wavelength Hyper Red 640 nm IF=20mA D 1 Dominant Wavelength Hyper Red 625 nm IF=20mA 1/2 Spectral Line Half-width Hyper Red 20 nm IF=20mA C Capacitance Hyper Red 27 pF VF=0V f=1MHz VF 2 Forward Voltage Hyper Red 2.2 2.8 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Notes: 1.Wavelength: +/-1nm. 2. Forward Voltage: +/-0.1V. 3. Wavelength value is traceable to the CIE127-2007 compliant national standards. Absolute Maximum Ratings at TA=25C Parameter Hyper Red Units Power dissipation 84 mW DC Forward Current 30 mA Peak Forward Current 1 150 mA Reverse Voltage 5 V Operating/Storage Temperature -40C To +85C Lead Solder Temperature 2 260C For 3 Seconds Lead Solder Temperature 3 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAM7945 REV NO: V.2A DATE: JUN/14/2013 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Y.Liu ERP: 1101032229