ANT-1.4-CW-HWR-ccc Data Sheet by Product Description 8.2 mm (0.32 ) HWR Series -wave center-fed dipole antennas deliver outstanding performance in a rugged and cosmetically attractive package. The articulating base allows the antenna to tilt 90 degrees and rotate 360 degrees. The antennas internal counterpoise eliminates external ground plane dependence and maximizes performance. HWR Series antennas attach via a standard SMA or Part 15 compliant RP-SMA connector. Custom colors and connectors are available for volume OEM customers. 116 mm (4.57 ) 142 mm Features (5.59 ) Internal counterpoise Low cost Tilts and rotates Omni-directional pattern Outstanding VSWR Rugged & damage-resistant Standard SMA or Part 15 compliant RP-SMA connector Custom colors and terminations for volume 26 mm OEMs (1.02 ) Internal O-ring seal on connector Electrical Specifications 10 mm 30 mm Center Frequency: 1.4GHz (0.39 ) (1.18 ) Recom. Freq. Range: 1.351.45GHz Bandwidth: 100MHz Ordering Information Wavelength: -wave ANT-1.4-CW-HWR-RPS (with RP-SMA connector) VSWR: 2.0 typical ANT-1.4-CW-HWR-SMA (with SMA connector) Peak Gain: 2.4dBi Impedance: 50-ohms Connection: RP-SMA or SMA Oper. Temp. Range: 30C to +80C Electrical specifications and plots measured with a 10.16 cm x 10.16 cm (4.00 x 4.00) reference ground plane 1 Revised 8/1/2017VSWR Graph VSWR 1.324 Reflected Power 25% 3:1 11% 2:1 0% 1:1 1.3GHz 1.4GHz 1.5GHz What is VSWR The Voltage Standing Wave Ratio (VSWR) is a measurement of how well an antenna is matched to a source impedance, typically 50-ohms. It is calculated by measuring the voltage wave that is headed toward the load versus the voltage wave that is reflected back from the load. A perfect match has a VSWR of 1:1. The higher the first number, the worse the match, and the more inefficient the system. Since a perfect match cannot ever be obtained, some benchmark for performance needs to be set. In the case of antenna VSWR, this is usually 2:1. At this point, 88.9% of the energy sent to the antenna by the transmitter is radiated into free space and 11.1% is either reflected back into the source or lost as heat on the structure of the antenna. In the other direction, 88.9% of the energy recovered by the antenna is transferred into the receiver. As a side note, since the :1 is always implied, many data sheets will remove it and just display the first number. How to Read a VSWR Graph VSWR is usually displayed graphically versus frequency. The lowest point on the graph is the antennas operational center frequency. In most cases, this is different than the designed center frequency due to fabrication tolerances. The VSWR at that point denotes how close to 50-ohms the antenna gets. Linx specifies the recommended bandwidth as the range where the typical antenna VSWR is less than 2:1. Copyright 2017 Linx Technologies 159 Ort Lane, Merlin, OR 97532 Phone: +1 541 471 6256 Fax: +1 541 471 6251 2 ANT-1.4-CW-HWR-ccc Data Sheet www.linxtechnologies.com by