Thyristors Surface Mount 600V - 800V > MC4DCM, MAC4DCN Pb MC4DCM, MAC4DCN Description Designed for high volume, low cost, industrial and consumer applications such as motor control process control temperature, light and speed control. Features Small Size Surface Mount DPAK Package Passivated Die for Reliability and Uniformity Blocking Voltage to 800 V OnState Current Rating of 4.0 A RMS at 108C High Immunity to dv/dt 500 V/s at 125C High Immunity to di/dt 6.0 A/ms at 125C Epoxy Meets UL 94 V0 0.125 in Pin Out ESD Ratings: Human Body Model, 3B > 8000 V Machine Model, C > 400 V PbFree Packages are Available 4 4 Functional Diagram 2 1 3 1 MT2 MT1 2 G 3 Additional Information Datasheet Resources Samples 2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 08/30/17Thyristors Surface Mount 600V - 800V > MC4DCM, MAC4DCN Maximum Ratings (T = 25C unless otherwise noted) J Rating Symbol Value Unit Peak Repetitive Off-State Voltage (Note 1) V , DRM (Gate Open, Sine Wave 50 to 60 Hz, T = -40 to 125C) J V V RRM 600 MAC4DCM 800 MAC4DCM On-State RMS Current (Full Cycle Sine Wave, 60 Hz, T = 108C) I 4.0 A C T (RMS) Peak Non-Repetitive Surge Current I 40 A TSM (One Full Cycle Sine Wave, 60 Hz, T = 125C) C 2 Circuit Fusing Consideration (t = 8.3 msec) I t 6.6 Asec Peak Gate Current (Pulse Width 20 sec, T = 108C) I 4.0 W C GM Peak Gate Power (Pulse Width 10 sec, T = 108C) P 2.0 W C GM Average Gate Power (t = 8.3 msec, T = 108C) P 1.0 W G(AV) C Operating Junction Temperature Range T -40 to +125 C J Storage Temperature Range T -40 to +125 C stg Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability. 1. V and V for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage however, positive gate voltage shall not be applied concurrent with negative DRM RRM potential on the anode. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded. Thermal Characteristics Rating Symbol Value Unit R Thermal Resistance, JunctiontoCase (AC) JC 3.5 R JunctiontoAmbient JA C/W 88 R 80 JunctiontoAmbient (Note 2) JA Maximum Lead Temperature for Soldering Purposes, 1/8 from case for 260 C T L 10 seconds (Note 3) 2. These ratings are applicable when surface mounted on the minimum pad sizes recommended. 3. 1/8 from case for 10 seconds. 2017 Littelfuse, Inc. Specifications are subject to change without notice. Revised: 08/30/17