PRODUCT BRIEF PhlatLight LED Development Kit Product Brief DK-136M Series and DK-125M Series Overview Main Features The DK-136M and DK-125M de- Can be operated either in pulsed or continuous waveform velopment kits for PhlatLight (CW) modes products are comprehensive Static current control via on board dial knob solutions designed specifically Pulse width modulation input supports pulsed mode opera- to allow for evaluation of prod- tion with duty cycles ranging from 20% to 75% ucts in minutes. The kits are a complete solution including Optional dynamic current control by user-supplied external high-current drivers optimized device. Interface allows drive currents ranging from 0 to for each device and an effi- Max If, controlled by 0-5V input voltage cient thermal management in- Frequencies up to 3kHz in pulsed mode frastructure to ensure the devices can be operated at their optimum point, whether it is Device and circuit parameters reading through test points, for maximum brightness, maximum efficiency or somewhere in- including: between. This plug and play solution can easily be connected to Forward voltage, V . F standard laboratory equipment through standard connectors and allows system designers to save weeks in their development Forward current, I . F cycles. Device temperature monitoring through thermistor. Typical thermal resistance of 0.3C/W from heat sink to Key Features ambient Compatibility with all CBT and PT series PhlatLight products Driver circuitry based off of Maxim MAX16818 IC DK-136M series kits are optimized for CBT-120 and PT-120 de- vices. DK-125M series kits are optimized for CBT-90 and PT-85 devices. Driver board supply currents of 36A with DK-136M series kits and 25A with DK-125M series kits. Available in a single channel or three channel versions www.luminus.com 2008 Luminus Devices, Inc. - All Rights Reserved PDB-001290 Rev 01PhlatLight Development Kit Development Kit Contents User equipment Required 1 or 3 driver cards optimized for the device evaluated Standard 12V laboratory power supply. 1 or 3 air-cooled heat sinks. Standard instrumentation - volt meter, oscilloscope. Electrical wiring between driver and PhlatLight devices Pulse generator for PWM dimming in CW mode. Thermal interface materials and mounting hardware Optional dynamic current management solution User manual including step-by-step instructions for set-up Note: PhlatLight LED products are not included in the develop- and operation of the kit. ment kits and must be purchased separately. Product Compatibility Development Kit Part Number Compatible PhlatLight LEDs * * * DK-125M-1, DK-125M-3 CBT-90 , CST-90 , CBT-120 , PT-85 , PT-120 * * DK-136M-1, DK-136M-3 CBT-90 , CBT-120 , PT-120 Note *: Recommended product for optimal use Note : Product can be used, but not operated at optimal conditions Ordering Information Ordering Part Number Product Description DK-125M PhlatLight Development Kit, Single channel development kit, with 25A driver board, heat DK-125M-1 Single Channel sink, cable assemblies and user manual DK-125M PhlatLight Development Kit, Three channel development kit, with 25A driver board, heat DK-125M-3 Three Channels sink, cable assemblies and user manual DK-136M PhlatLight Development Kit, Single channel development kit, with 36A driver board, heat DK-136M-1 Single Channel sink, cable assemblies and user manual DK-136M PhlatLight Development Kit, Three channel development kit, with 36A driver board, heat DK-136M-3 Three Channels sink, cable assemblies and user manual The products, their specifications and other information appearing in this document are subject to change by Luminus Devices without notice. Luminus Devices assumes no liability for errors that may appear in this document, and no liability otherwise arising from the application or use of the product or information contained herein. None of the information provided herein should be considered to be a representation of the fitness or suitability of the product for any particular application or as any other form of warranty. Luminus Devices product warranties are limited to only such warranties as accompany a purchase contract or purchase order for such products. Nothing herein is to be construed as constituting an additional warranty. No infor- mation contained in this publication may be considered as a waiver by Luminus Devices of any intellectual property rights that Luminus Devices may have in such information. PhlatLight is a registered trademark of Luminus Devices, Inc., all rights reserved. Luminus Devices 1100 Technology Park Drive 978-528-8000 (T) Billerica, MA 01821 978-528-8001 (F) E-mail: sales luminus.com www.luminus.com www.luminus.com 2008 Luminus Devices, Inc. - All Rights Reserved Page 2