Photodiode in Plastic Surface Mount Package
PDB-C160SM
WWW.LUNAINC.COM Precision Control Results
DESCRIPTION FEATURES
The PDB-C160SM is a red enhanced PIN silicon photodiode ideal for high
Surface Mount
speed photoconductive applications packaged in a surface mount
Photoconductive
package.
High Speed
Low cost
RELIABILITY APPLICATIONS
Contact Luna for recommendations on specific test conditions and
Photointerrupters
procedures.
Industrial Electronics
IR Remote Control
Control & Drive Circuits
ABSOLUTE MAXIMUM RATINGS
SYMBOL MIN MAX UNITS
Reverse Voltage - - 32 V T = 25C UNLESS OTHERWISE NOTED
a
Storage Temperature -40 - +100 C -
Operating Temperature -40 to +100 C -
Soldering Temperature* - - +260 C -
* 1/16 inch from case for 3 seconds max.
Information in this technical datasheet is believed to
REV 04-20-17
be correct and reliable. However, no responsibility is
Page 1/3
assumed for possible inaccuracies or omission.
2016 Luna Optoelectronics. All rights reserved.
Specifications are subject to change without notice.
Luna Optoelectronics, 1240 Avenida Acaso, Camarillo CA 93012 Phone (805) 987-0146 Fax (805) 484-9935
Photodiode in Plastic Surface Mount Package
PDB-C160SM
WWW.LUNAINC.COM Precision Control Results
T = 25C UNLESS NOTED OTHERWISE
a
OPTO-ELECTRICAL PARAMETERS
PARAMETER
TEST CONDITIONS MIN TYP MAX UNITS
Short Circuit Current H= 100 fc, 2856 K - 80 95 A
Dark Current V = 10 V - 2 30 nA
R
Shunt Resistance V = 10 mV - 250 - MW
R
Junction Capacitance V =0V; f = 1 MHz - 72 - pF
R
Spectral Application Range Spot Scan 400 - 1100 nm
Peak Wave Length = 850nm - .62 - A/W
-14
Noise Equivalent Power - 4.1x10 - W/
V =10V@= Peak Hz
R
Response Time** - 20 - nS
RL = 50, V = 5V, = 850nm,
R
**Response time of 10% to 90% is specified at 850nm wavelength light.
SOLDERING
RECOMMENDATION
Wave Not Advised
IR Oven Reflow Recommended See reflow profile.
Forced Convection Reflow Recommended See reflow profile.
Convection Reflow Recommended See reflow profile.
Vapor Phase Reflow Recommended See reflow profile.
Manual Allowed 260C for 3 seconds max.
Moisture Sensitivity Level 4 J-STD-033
TYPICAL PERFORMANCE
SPECTRAL RESPONSE SOLDER PAD LAYOUT
SOLDER PAD LAYOUT, mm
1.45
1.45
1.00 C 1.80
A
5.90
Information in this technical datasheet is believed to
REV 04-20-17
be correct and reliable. However, no responsibility is
Page 2/3
assumed for possible inaccuracies or omission.
2016 Luna Optoelectronics. All rights reserved.
Specifications are subject to change without notice.
Luna Optoelectronics, 1240 Avenida Acaso, Camarillo CA 93012 Phone (805) 987-0146 Fax (805) 484-9935