2. Soldering the headers
Before using your click board, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
1
nRF C click
2 3
1. Introduction
4. Essential features
nRF C Click with its nRF24L01P IC is
designed for operation in the world wide ISM
frequency band at 2.400 - 2.4835 GHz. The
board supports an air data rate of 250 Kbps,
1 Mbps and 2 Mbps and it is suitable for ultra
Turn the board upside down so that Turn the board upward again. Make sure low power designs. All these features make
bottom side is facing you upwards. Place to align the headers so that they are this board ideal for wireless PC peripherals,
shorter parts of the header pins in both perpendicular to the board, then solder the remotes, VoIP headsets, game controllers,
soldering pad locations. pins carefully. sensors, home and commercial automation,
active RFID, toys and many more.
nRF C Click is an add-on board in mikroBUS
form factor. Its a compact and easy solution
3. Plugging the board in
for adding 2.4 GHz transceiver to your design.
click
It features nRF24L01P 2.4 GHz transceiver Once you have soldered the headers your
module with an embedded baseband protocol board is ready to be placed into desired
BOARD
engine as well as 2.4 GHz SMD chip antenna. mikroBUS socket. Make sure to align the
www.mikroe.com
nRF C Click communicates with target cut in the lower-right part of the board
board microcontroller via mikroBUS SPI with the markings on the silkscreen at the
nRF C click Manual
(SDI, SDO, SCK, CS#), CE and INT lines. mikroBUS socket. If all of the pins are
ver. 1.01
The board is designed to use 3.3V power aligned correctly, push the board all the way
supply only. LED diode (green) indicates into the socket.
the presence of power supply. 0 100000 0223066. Chip or Trace antenna?
5. nRF C Click Board Schematic
If you need the
board with PCB
trace antenna,
we recommend
you to use other
board such as
nRF T Click :
R3
22K