2. Soldering the headers Before using your click board, make sure to solder 1x8 male headers to both left and right side of the board. Two 1x8 male headers are included with the board in the package. 1 PROTO click 2 3 1. Introduction 4. Application and features PROTO click board is a cheap and eectivff e solution for creating click board of your own design. Add sensors, drivers, passive Turn the board upside down so that Turn the board upward again. Make sure components and make the click board bottom side is facing you upwards. to align the headers so that they are which suits your project needs. You can Place shorter pins of the header into the perpendicular to the board, then solder the use it with all your favorite development appropriate soldering pads. pins carefully. boards with mikroBUS sockets. PROTO click is an accessory board in 3. Plugging the board in mikroBUS form factor. It features 10x11 click prototyping area as well as additional power Once you have soldered the headers your pads. It can be used to assemble custom board is ready to be placed into desired BOARD electronics thus creating a custom click mikroBUS socket. Make sure to align the 2 www.mikroe.com board. PROTO click contains mikroBUS I C cut in the lower-right part of the board (SDA, SCL), SPI (MISO, MOSI, SCK, CS), UART with the markings on the silkscreen at PROTO click Manual ver. 1.00 (TX, RX), PWM, INT, AN and RST lines from the mikroBUS socket. If all of the pins are the target board microcontroller. The board aligned correctly, push the board all provides 3.3 V and 5 V power supply. the way into the socket. 0 100000 025192 5. PROTO click Board Schematic 6. Board Dimensions 3.3V 5V AN PWM INT RST Legend CS TX SCK RX mm SCL MISO mils SDA MOSI +3.3V +5V GND GND 7. Support MikroElektronika oers ff Free Tech Support (www.mikroe.com/support) until the end of product lifetime, so if something goes wrong, we are ready and willing to help MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document. Specification and information contained in the present schematic are subject to change at any time without notice. Copyright 2013 MikroElektronika. All rights reserved.