2. Soldering the headers Before using your click board, make sure to solder 1x8 male headers to both left and right side of the board. Two 1x8 male headers are included with the board in the package. 1 UNIQUE ID click 2 3 4. Essential features The DS2401 IC consists of a factory- lasered 64-bit ROM that includes a unique 48-bit serial number, an 8-bit CRC, and an 8-bit family code. The data is transferred serially through the 1-Wire interface. The unique number can then be used as a PCB Turn the board upside down so that Turn the board upward again. Make sure identification, to establish a network node the bottom side is facing you upwards. to align the headers so that they are ID, for equipment registration and similar Place shorter pins of the header into the perpendicular to the board, then solder the purposes. Additionally, the multidrop appropriate soldering pads. pins carefully. capability of DS2401 enables multiple devices to reside on a single data line. 1. Introduction 3. Plugging the board in Unique ID click carries DS2401, an en- click hanced silicon serial number IC. Its a low Once you have soldered the headers your cost solution for providing a unique reg- board is ready to be placed into the desired BOARD istration number to your design. The chip mikroBUS socket. Make sure to align the cut in www.mikroe.com uses 1-Wire communications for interfacing the lower-right part of the board with the with the target board microcontroller, either markings on the silkscreen through a GP1 or GP0 pin (here in place of at the mikroBUS socket. UNIQUE ID click manual ver 1.00 the default AN and PWM mikroBUS pins). If all the pins are aligned The board is designed to use either a 3.3V or correctly, push the board all 5V power supply. the way into the socket. 01000000748628. Code examples 5. Schematic Once you have done all the necessary preparations, its time to get your click board up and running. We have provided examples VCC VCC for mikroC , mikroBasic and mikroPascal compilers on our Libstock website. Just R2 GPIO1 GPIO0 4K7 3 AN PWM GPIO1 U1 download them and you are ready to start. R1 1 6 RST INT 2K2 VCC-3.3V VCC-5V GND NC CS TX 2 OW 2 5 DATA NC SCK RX 3 4 NC NC SCL 1 GPIO0 MISO SDA DS2401 MOSI .com GPIO SEL. PWR +3.3V +5V GND GND MIKROBUS DEVICE CONN. 9. Support VOLTAGE SEL. MikroElektronika offers free tech support (www.mikroe.com/support) until the end of VCC-3.3V VCC-5V the products lifetime, so if something goes wrong, were ready and willing to help VCC 6. Dimensions 7. SMD jumper 10. Disclaimer The board features MikroElektronika assumes no responsibility mm mils a GPIO SEL. jumper or liability for any errors or inaccuracies (zero ohm resistor) that may appear in the present document. LENGTH 28.57 1125 that allows you to Specification and information contained in WIDTH 25.4 1000 choose between the present schematic are subject to change HEIGHT* 3.5 135.8 two available pins for the 1-Wire interface. at any time without notice. 28.57 mm / 1125 mils * without headers Copyright 2015 MikroElektronika. All rights reserved. 25.4 mm / 1000 mils 1 2 3