63444-2025 Molex

Fine Adjust Applicator for Sabre Flat Blade Crimp Terminal FineAdjust Applicator Specification Sheet Order No. 63901-2600 FEATURES Directly adapts to most automatic wire processing machines Quick punch removal with the push of a button for fast and easy tooling change Applicator designed to industry standard mounting and shut height 135.80mm (5.346 ) Quick set-up time plus the crimp height, track and feed adjustments can be set without removing the applicator from the press Fine adjustment allows users to achieve target with little effort by adjusting in increments of .015mm (.0006 ) for conductor crimp height and .063mm (.0025 ) for insulation height Independent adjustment rings allow users to quickly adjust the conductor or insulation crimp height without affecting each other SCOPE Products: Sabre Flat Blade Crimp Terminal-18-20 AWG, UL1015 wires. Wire Size Insulation Diameter Strip Length Terminal Series No. Terminal Order No. AWG mm mm In. mm In. 43374 43374-2001 18-20 0.80-0.50 2.54-2.85 .100-.112 3.96-5.54 .156-.218 43375 43375-2001 18-20 0.80-0.50 2.54-2.85 .100-.112 3.96-5.54 .156-.218 Insulation crimp to meet IPC/WHMA-A-620 Class 2 compliance. Note: Terminal will accommodate the UL1015 wires. For UL1007 wires use Applicator 63901-2500. DEFINITION OF TERMS BEND UP ROLLING SEAM BELL CONDUCTOR BRUSH MOUTH CRIMP INSULATION CRIMP TWISTING STRIP LENGTH BEND DOWN CUT-OFF TAB CRIMP HEIGHT The above terminal drawing is a generic terminal representation. It is not an image of any terminal listed in the scope. Doc No. ATS-639012600 Release Date: 07-08-09 UNCONTROLLED COPY Page 1 of 5 Revision: B Revision Date: 01-26-10 Fine Adjust Applicator for Sabre Flat Blade Crimp Terminal CRIMP SPECIFICATION Cut-off Tab Conductor Brush Bell mouth Terminal Series No. Maximum Maximum mm In. mm In. mm In. 43374 0.20-0.50 .008-.020 0.30 .012 0.76 .030 43375 Punch Width (Ref) Seam Bend up Bend down Twist Roll Terminal Series No. Conductor Insulation Degree (Max) Degree (Max) mm In mm In Seam shall not be open and no wire allowed out 43374 3 3 4 8 2.00 .079 3.20 .126 of the crimping area 43375 After crimping, the conductor profile should measure the following. Insulation Crimp Height Pull Force Wire Size Conductor Crimp Height Terminal Series No. (Ref) Minimum 2 AWG mm mm In. mm In. N Lb. 18 0.80 1.16-1.26 .046-.050 3.00 .118 89.0 20.00 43374 20 0.50 1.10-1.20 .043-.047 2.80 .110 57.9 13.00 18 0.80 1.16-1.26 .046-.050 3.00 .118 89.0 20.00 43375 20 0.50 1.10-1.20 .043-.047 2.80 .110 57.9 13.00 Pull Force should be measured with no influence from the insulation crimp. The above specifications are guidelines to an optimum crimp. Doc No. ATS-639012600 Release Date: 07-08-09 UNCONTROLLED COPY Page 2 of 5 Revision: B Revision Date: 01-26-10