63445-2541 Molex

Fine Adjust Applicator for Mini-Fit TPA 2.0 Crimp Terminals FineAdjust Applicator Application Tooling Specification Sheet Order No. 63903-6700 FEATURES Directly adapts to most automatic wire processing machines Quick punch removal with the push of a button for fast and easy tooling change Applicator designed to industry standard mounting and shut height 135.80mm (5.346 ) Quick set-up time plus the crimp height, track and feed adjustments can be set without removing the applicator from the press Fine adjustment allows users to achieve target with little effort by adjusting in increments of .015mm (.0006 ) for conductor crimp height and .063mm (.0025 ) for insulation height Independent adjustment rings allow users to quickly adjust the conductor or insulation crimp height without affecting each other SCOPE Products: Mini-Fit TPA 2.0 Crimp Terminals, 16 AWG wires. Insulation Diameter Wire Size Strip Length Terminal Series No. Terminal Order No. IPC/WHMA-A620 (1) Terminal (2) AWG mm mm In. mm In. mm In. 172718-1111 172718 172718-1121 16 --- 1.98-2.55 .078-.100 1.98-2.55 .078-.100 3.20-3.80 .126-.150 172765-1111 172765 172765-1121 (1) To achieve optimum IPC-A620 insulation crimps, use this insulation OD range. (2) Overall insulation OD specification for terminal. BEND UP DEFINITION OF TERMS TWISTING STRIP LENGTH BRUSH BELL MOUTH ROLLING WIRE BEND DOWN SEAM CUT-OFF CONDUCTOR TAB CRIMP HEIGHT INSULATION CRIMP HEIGHT Doc No: ATS-639036700 Release Date: 03-15-16 UNCONTROLLED COPY Page 1 of 5 Revision: A Revision Date: 03-15-16 Fine Adjust Applicator for Mini-Fit TPA 2.0 Crimp Terminals CRIMP SPECIFICATION Bell mouth Cut-off Tab Maximum Conductor Brush Terminal Series No. mm In. mm In. mm In. 172718 0.20-0.70 .008-.028 .30 .012 0.20-0.80 .008-.032 172765 Punch Width (Ref) Seam Bend up Bend down Twist Roll Terminal Series No. Conductor Insulation Degree (Max) Degree (Max) mm In mm In Seam shall not be open and no wire allowed out 172718 3 3 3 5 1.80 .071 2.50 .098 of the crimping area 172765 After crimping, the conductor profile should measure the following. Conductor Wire Size Pull Force Minimum Terminal Series No. Crimp Height Crimp Width (Ref) 2 AWG mm mm In. mm In. N Lb. 172718 16 --- 1.18-1.28 .046-.050 1.80 .071 133.5 30.0 172765 Insulation Wire Size Terminal Series No. Crimp Height (Ref) Crimp Width (Ref) 2 AWG mm mm In. Mm In. 172718 16 --- 2.50 .098 2.60 .102 172765 Tool Qualification Notes: 1. Pull Force should be measured with no influence from the insulation crimp. 2. The above specifications are guidelines to an optimum crimp. Doc No: ATS-639036700 Release Date: 03-15-16 UNCONTROLLED COPY Page 2 of 5 Revision: A Revision Date: 03-15-16