Product Information

63454-0025

63454-0025 electronic component of Molex

Datasheet
Board to Board & Mezzanine Connectors INSULATION PUNCH

Manufacturer: Molex
This product is classified as Large/Heavy, additional shipping charges may apply. A customer service representative may contact you after ordering to confirm exact shipping charges



Price (USD)

1: USD 335.0077 ea
Line Total: USD 335.01

0 - Global Stock
MOQ: 1  Multiples: 1
Pack Size: 1
Availability Price Quantity
0 - WHS 1


Ships to you between Tue. 28 May to Thu. 30 May

MOQ : 6
Multiples : 6
6 : USD 337.226
12 : USD 314.2835
102 : USD 314.249
252 : USD 302.1855

     
Manufacturer
Product Category
Brand
Product Type
Factory Pack Quantity :
Subcategory
Cnhts
Hts Code
Mxhts
LoadingGif

Notes:- Show Stocked Products With Similar Attributes.
Image Description
35068-9702 electronic component of Molex 35068-9702

Molex Terminals MP LOCK TERM FR WIRE RM FR WIRE AWG 22-20
Stock : 3400

35746-0210 electronic component of Molex 35746-0210

Headers & Wire Housings .070" CRMP 14-18 AWG FE
Stock : 7180

35746-0410 electronic component of Molex 35746-0410

Headers & Wire Housings 1.8mm WtW Crp Fem /P rp Fem /PolzDmp Term
Stock : 3600

35748-0210 electronic component of Molex 35748-0210

Headers & Wire Housings FML CRIMP 14-18AWG Reel of 4000
Stock : 1200

39-00-0372 electronic component of Molex 39-00-0372

Molex Headers & Wire Housings MINI KK CRIMP RECEPT
Stock : 211363

35747-0110 electronic component of Molex 35747-0110

Headers & Wire Housings 1.8TEB+REC.MALE CR.T LE CR.TERM 357470110
Stock : 80600

35747-0210 electronic component of Molex 35747-0210

Headers & Wire Housings 1.8MM SEC.LOCK MALE MALE TERM 357470210
Stock : 400

35747-0410 electronic component of Molex 35747-0410

Headers & Wire Housings 1.8mm WtW Crp M /Pol Crp M /PolzDmp Term
Stock : 4590

50058-8000 electronic component of Molex 50058-8000

Headers & Wire Housings PCBLD TERM 28-32G F Reel of 25000
Stock : 136561

54550-2094-C electronic component of Molex 54550-2094-C

FFC & FPC Connectors Connectors
Stock : 30

Image Description
Hot SSW-106-03-T-S electronic component of Samtec SSW-106-03-T-S

Board to Board & Mezzanine Connectors Tiger Buy Socket Strip with PCB Tails, 0.100 Pitch
Stock : 1

DF40HC(3.0)-50DS-0.4V(51) electronic component of Hirose DF40HC(3.0)-50DS-0.4V(51)

Board to Board & Mezzanine Connectors 50P RECPT 3.0 STK HT W/O METAL FITTING
Stock : 909

Hot SSW-108-03-T-S electronic component of Samtec SSW-108-03-T-S

Board to Board & Mezzanine Connectors Tiger Buy Socket Strip with PCB Tails, 0.100 Pitch
Stock : 1

SSW-107-02-G-S-RA electronic component of Samtec SSW-107-02-G-S-RA

Board to Board & Mezzanine Connectors Tiger Buy Socket Strip with PCB Tails, 0.100 Pitch
Stock : 1

SSW-104-02-G-S-RA electronic component of Samtec SSW-104-02-G-S-RA

Board to Board & Mezzanine Connectors Tiger Buy Socket Strip with PCB Tails, 0.100 Pitch
Stock : 1

SSW-102-02-G-D electronic component of Samtec SSW-102-02-G-D

Board to Board & Mezzanine Connectors Tiger Buy Socket Strip with PCB Tails, 0.100 Pitch
Stock : 1

SSW-102-02-T-S-RA electronic component of Samtec SSW-102-02-T-S-RA

Board to Board & Mezzanine Connectors Tiger Buy Socket Strip with PCB Tails, 0.100 Pitch
Stock : 1

DW-02-17-T-S-260 electronic component of Samtec DW-02-17-T-S-260

Board to Board & Mezzanine Connectors .100" Flex Stack, Flexible Board Stacker, .110" Tail
Stock : 1

ZW-02-15-T-S-435-100 electronic component of Samtec ZW-02-15-T-S-435-100

Board to Board & Mezzanine Connectors .100" Flex Stack, Flexible Board Stacker, Custom Tail
Stock : 1

X0511WVS-10AS-LPV01 electronic component of XKB X0511WVS-10AS-LPV01

0.5mm 2 10 -25℃~+85℃ Brick nogging male 500mA SMD,P=0.5mm Mezzanine Connectors (Board to Board) ROHS
Stock : 2490

Fine Adjust Applicator for SRC Connector using MX150 Receptacle Terminals FineAdjust Applicator Application Tooling Specification Sheet Order No. 63904-0400 FEATURES THIS APPLICATOR IS FOR AUTOMATIC WIRE PROCESSOR USE ONLY. Quick punch removal with the push of a button for fast and easy tooling change Applicator designed to industry standard mounting and shut height 135.80mm (5.346 ) Quick set-up time plus the crimp height, track and feed adjustments can be set without removing the applicator from the press Fine adjustment allows users to achieve target with little effort by adjusting in increments of .015mm (.0006 ) for conductor crimp height and .063mm (.0025 ) for insulation height Independent adjustment rings allow users to quickly adjust the conductor or insulation crimp height without affecting each other Directly adapts to most automatic wire processing machines SCOPE 2 Products: SRC Connector using MX150 Receptacle Terminals, 0.75mm wires. Wire Size Insulation Diameter Strip Length Terminal Series No. Terminal Order No. Wire Type mm mm In. mm In. 33001 33001-3004 33001-5002 FLRY-B 0.75 1.70-1.90 .067-.075 4.70-5.60 .185-.220 33012 33012-3002 FLRY-B 0.75 1.70-1.90 .067-.075 4.70-5.60 .185-.220 Terminals were validated using the following wire specifications: ISO 6722-1, Class B. DEFINITION OF TERMS BRUSH BEND UP WIRE BRUSH MUST BE 0.30 CUT-OFF FLUSH OR BELOW TOP TAB (NO BURR) OF CONDUCTOR CRIMP ROLLING BELL MOUTH STRIP LENGTH TWISTING INSULATION BEND CRIMP DOWN SEAM THIS AREA CONDUCTOR CRIMP CRIMP HEIGHT TERMINAL WIDTH NOT TO EXCEED 2.75mm AFTER CRIMP Doc No: ATS-639040400 Release Date: 02-24-16 CONTROLLED COPY Page 1 of 5 Revision: A Revision Date: 02-24-16 Fine Adjust Applicator for SRC Connector using MX150 Receptacle Terminals CRIMP SPECIFICATION Bell mouth Cut-off Tab (Max) Conductor Brush (Max) Terminal Series No. mm In. mm In. mm In. 33001 0.30-0.70 .012-.028 0.50 .020 0.40 .016 33012 0.30-0.70 .012-.028 0.50 .020 0.40 .016 Wire brush must be flush or below top of Conductor Crimp. THIS APPLICATOR IS INTENDED FOR AUTOMATIC WIRE PROCESSOR USE ONLY. It is very important that the brush length is consistently within specification for this sealed connector system to work properly. This applicator should only be run in a properly setup automatic wire processor in order to consistently achieve the brush length. Any attempt to use this applicator outside a properly setup automatic wire processor will likely not meet the brush specification and cause this sealed connector system to not work properly. Punch Width (Ref) Terminal Bend up Bend down Twist Roll Conductor Seam Conductor Insulation Series No. Seam shall not be Degree Degree mm In mm In open and no wire allowed 33001 3 3 3 3 2.10 .083 2.16 .085 out of the crimping area 33012 3 3 3 3 2.10 .083 2.16 .085 After crimping, the crimp profiles should measure the following: Conductor Insulation Pull Force Terminal Wire Size Minimum Crimp Height Crimp Width Crimp Height (Ref) Crimp Width (Ref) Series No. 2 Wire Type mm mm In. mm In. mm In. mm In. N Lb. 33001 FLRY-B 0.75 1.20-1.30 .047-.051 2.05-2.25 .081-.089 2.30 .091 2.20 .087 90 20.2 33012 FLRY-B 0.75 1.20-1.30 .047-.051 2.05-2.25 .081-.089 2.30 .091 2.20 .087 90 20.2 Tool Qualification Notes: 1. Pull Force should be measured with no influence from the insulation crimp. 2. The above specifications are guidelines to an optimum crimp. Adjusting the Wire Brush Length (See Item11 in parts list and assembly drawing.) 1. If the wire brush is too long or extends above the top of the conductor crimp, adjust the Wire Stop, Item 11, closer to the conductor punch. 2. If the wire brush is too short, adjust the Wire Stop further away from the conductor punch. Doc No: ATS-639040400 Release Date: 02-24-16 CONTROLLED COPY Page 2 of 5 Revision: A Revision Date: 02-24-16

Tariff Desc

8536.69.10 62 Plugs and sockets for co-axial cables or printed circuits Free

8536.69.90 CONNECTORS, ELECTRICAL, being ANY of the following:
(a) plugs;
(b) sockets;
(c) adaptors
TC 1225594

8536.69.90 PLUG AND SOCKET COMBINATIONS, being ANY of the following:
(a) 2, 3, 4, 6, 9, 12 OR 15 way, rated to 300 V, maximum current of 15 amps;
(b) 2, 3 OR 12 way, single in line pin header;
(c) 1.3mm plug to 2.1mm socket;
(d) 2.5mm plug to 3.5mm socket
TC 9900931

8536.69.90 SOCKETS, being ANY of the following:
(a) single pin, NOT exceeding 3.5 mm;
(b) micro, single pin, 2 mm;
(c) DC power connector, 2.1 mm OR 2.5 mm;
(d) 9 pin OR 15 pin, sub D;
(e) 2, 4 OR 8 pole microphone connector;
(f) 2, 3, 5, 6, 7, 8 OR 13 pin DIN;
(g) 16, 20, 26, 34, 40 OR 50 way dual in line crimp-on
TC 9900883

8536.69 JACKS, phono, RCA Type
TC 8438480

8536.69.90 CONNECTORS, electrical, incorporating twist locking mechanism
TC 9703905

8536.70.90 CONNECTORS, OPTICAL Op. 12.06.2007 FIBRE
TC 0708845

8536.69 PLUGS, modular, telephone, to suit RJ 11 sockets and complying with US Standard FCC 68
TC 9203687

8536.90.90 LUGS, being solderable, copper connectors
TC 0613954

8535.90.00 CRIMPING TERMINALS, having bell-mouth OR flared cable entry
TC 9504891

8536.90 HOLDERS, dry cell
TC 8438464

8536.69.90 TC 1440896 POWER POINTS, plastic AND/OR metal, single OR multiple power outlet, with OR without EITHER of the following:
(a) LED (light-emitting diode) night light;
(b) single OR multiple power switches

8536.69 PLUGS/SOCKETS, adaptor being EITHER of the following:
(a) providing for plug or socket configurations used in other countries to connect to Australian standard plugs or sockets;
(b) providing for plug or socket configurations of Australian standard type to connect to plugs or sockets used in other countries
TC 8807068
AEROMOTIVE
BittWare
Brad
Brad Harrison
FCT
FCT - A MOLEX COMPANY
FCT Electronics
Flamar
FLAMAR - A MOLEX COMPANY
GW Connect
GWCONNECT BY MOLEX
HH
ML4
MOLEX
MOLEX - FLS SELECT
Molex / FCT
molex / gwconnect
MOLEX / WALDOM
MOLEX / WOODHEAD
Molex Connector Corporation
MOLEX ELECTRONICS
MOLEX FLAMAR
Molex Inc
MOLEX INDUSTRIAL
MOLEX INDUSTRIAL HDC
MOLEX PREMISE NETWORK
MOLEX WESTEC
Molex, LLC
Oplink
Sensorcon
Temp-Flex
Triton
Triton/ Molex LLC
WOODHEAD / MOLEX

Looking for help? Visit our FAQ's Section to answer to all your questions

 

X-ON Worldwide Electronics

Welcome To X-ON ELECTRONICS
For over three decades, we have been advocating and shaping the electronic components industry. Our management complements our worldwide business scope and focus. We are committed to innovation, backed by a strong business foundation. If you need a trustworthy supplier of electronic components for your business – look no further.
 

Copyright ©2024  X-ON Electronic Services. All rights reserved.
Please ensure you have read and understood our Terms & Conditions before purchasing.
All prices exclude GST.

Image for all the cards that are accepted Image for all the cards that are accepted Image for all the cards that are accepted Image for all the cards that are accepted Image for all the cards that are accepted