FineAdjust Applicator Safety Warnings and Information Read and understand all of the instructions and safety information in this manual before operating or servicing this tool. Keep this manual available when using this tool. Replacement manuals are available for download at no charge at www.molex.com. SAFETY ALERT SYMBOL This symbol is used to call your attention to hazards or unsafe practices which could result in an injury or property damage. The signal word, defined below, indicates the severity of the hazard. The message after the signal word provides information for preventing or avoiding the hazard. DANGER: Indicates an imminently hazardous situation which, if not avoided, could result in death or serious injury. DANGER WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. WARNING CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. CAUTION may also be used to alert against unsafe practices associated with events that could lead CAUTION to personal injury. WARNING WARNING Heavy Object Always wear proper eye protection when To avoid muscle strain or back injury, use lifting Operating or servicing this equipment. aids and proper lifting techniques when removing or replacing. Failure to wear eye protection could result Failure to observe these precautions may result in in serious eye injury from flying debris. injury or property damage. WARNING WARNING Never install or service this machine while Never wear clothing or jewelery that is loose or connected to any electrical power source. That could potentially hang into the equipement Disconnect power by unplugging the press and get caught. from its power source. Failure to observe this warning could result in Failure to observe this warning could result Severe Injury or death. In severe injury or death. WARNING WARNING Never operate, service, install, or adjust this Always hand cycle the applicator in the equipment machine without proper instruction and without to ensure the tooling is properly aligned. first reading and understanding the instructions in this manual and all applicable press and/or Failure to observe these precautions may result in wire processing machine. Injury or property damage. manuals. Doc. No: TM-638004900 Release Date: 09-04-03 UNCONTROLLED COPY Page 2 of 50 Revision: G Revision Date: 01-15-13