NXP Semiconductors Document Number: MPC17510 Rev. 6.0, 7/2016 Technical Data 1.2 A 15 V H-Bridge motor driver IC 17510 The 17510 is a monolithic H-Bridge designed to be used in portable electronic applications such as digital and SLR cameras to control small DC motors. The 17510 can operate efficiently with supply voltages as low as 2.0 V to as high as 15 V. Its low R H-Bridge output MOSFETs (0.45 typical) can provide DS(on) H-BRIDGE MOTOR DRIVER continuous motor drive currents of 1.2 A and handle peak currents up to 3.8 A. It is easily interfaced to low-cost MCUs via parallel 5.0 V compatible logic. The device can be pulse width modulated (PWMed) at up to 200 kHz. This device contains an integrated charge pump and level shifter (for gate drive voltages), integrated shoot-through current protection (cross-conduction suppression logic and timing), and undervoltage detection and shutdown circuitry. The 17510 has four operating modes: Forward, Reverse, Brake, and Tri-stated EJ Suffix (Pb-Free) EJ Suffix (Pb-Free) 98ASH70455A 98ASA00887D (high-impedance). This device is powered by SMARTMOS technology. 20-pin TSSOP 24-LEAD TSSOP with exposed pad Features 2.0 V to 15 V continuous operation Output current 1.2 A (DC), 3.8 A (peak) 450 m R H-Bridge MOSFETs DS(on) 5.0 V TTL- / CMOS-compatible inputs PWM frequencies up to 200 kHz Undervoltage shutdown Cross-conduction suppression 5.0 V 15 V 17510 VDD VM C1L GOUT C1H C2L C2H CRES OUT1 MOTOR EN GIN OUT2 MCU IN1 IN2 GND Figure 1. 17510 simplified application diagram 2016 NXP B.V.1 Orderable parts (1) Table 1. Orderable part variations Part number Temperature (T ) Package A MPC17510AEJ 20 TSSOP (exposed pad) -30 C to 65 C (2) MPC17510EJ 24 TSSOPW Notes 1. To order parts in Tape & Reel, add the R2 suffix to the part number. 2. Not recommended for new designs. 17510 2 NXP Semiconductors