AH-L03 Ohmite

AHL Series Low-frequency Single-phase Dual-stage EMI Filters These series range of double stage filters give superior performance when used in applications with low Impedance loads con- trolling pulsed, continuous and intermittent interference noise and where high levels of mains borne interference are present. Filter with additional differential mode FeA tureS AppLicA tionS rejection in low frequency. For use with switched mode power supplies to reduce Double stage filter Power Systems noise from power supply back into the Medical Version avail- Electronic Equipment mains. Filter also provides good attenuation able Frequency convertors of incoming interference Superior Per formance Stepper motor drives inSertion LoSS Chassis mounting UPS/Inverters -10 SerieS SpeciFicA tionS -20 Rated Leakage -30 current current (mA) Termination Weight -40 Part No. @40C @250VAC/50Hz Tab Screw (kg) -50 AH-L01 1A 0.34 6.3 x 0.8 0.125 -60 AH-L02 2A 0.34 6.3 x 0.8 0.125 1A -70 2A AH-L03 3A 0.34 6.3 x 0.8 0.17 3A -80 6A AH-L06 6A 0.34 6.3 x 0.8 0.17 -90 AH-L10 10A 0.34 6.3 x 0.8 0.17 AH-L15 15A 0.34 6.3 x 0.8 0.26 Start 30.00kHz Stop 30.00MHz AH-L20 20A 0.73 M5 0.65 AH-L25 25A 0.73 M5 0.65 -10 AH-L30 30A 0.73 M5 0.65 -20 AH-L35 35A 0.73 M5 1 -30 AH-L40 40A 0.73 M5 1 -40 AH-L50 50A 0.73 M6 2 -50 -60 10A cHArActeriSticS -70 15A 20A -80 Max. Cont. Oper. Voltage 250VAC 25A -90 Operating Frequency 50/60Hz Current ratings 1A to 50A @40C Start 30.00kHz Stop 30.00MHz High Potential test voltage L to G 2120Vdc for 1 Minute; L to L 1414Vdc for 1 Minute -10 Design corresponding to UL 60939-3, CSA 22.2 -20 No.8-13 and IEC 60939 -30 Overload Capability 135% of Rated current for 15 minutes -40 Flammability corresponding to UL 94 V-0 -50 -25C to +85C Temperature range -60 30A Climatic Category 25/85/21 -70 40A 50A Recommended Torque (Nm) M5: 1.0-2.0; M6: 1.25 2.5; M8: 2.5-5; M10: -80 3.5-7 -90 Start 30.00kHz Stop 30.00MHz (continued) 1-866-9-OHMITE Intl 1-847-258-0300 Fax 1-847-574-7522 www.ohmite.com info@ohmite.com 1AHL Series Low-frequency Single-phase Dual-stage EMI Filters circuit diAgrAm LD LC L L' Cy L L Cx Cx E I O R N A E Cy D N N' dimenSionS All dimensions in mm; Tolerances according to ISO2768-m 80 35A & 40A 5x6.2 1A & 2A 60.5 .2 73.5 .5 51 .3 100 .5 115 .25 130 27.5 .3 45 .3 6.3x0.8 4 8 50 .5 3A to 10A 75 .2 5 51 1 120 .5 64 33.5 .5 6.3x0.8 120 50A 85 .5 135 .25 120 15A 75 .2 150 5 51 1 4 62 39 1 8 70 .5 6.3x0.8 85 .5 20A to 30A 9.35 180 .5 78.5 ordering inFormA tion 86 .5 107 96.5 .3 Standard AH-L02 part numbers Series Low Current AH-L01 AH-L20 frequency rating AH-L02 AH-L25 40 1 46.5 7 AH-L03 AH-L30 AH-L06 AH-L35 AH-L10 AH-L40 AH-L15 AH-L50 100 .5 rev 08/20-1 2 1-866-9-OHMITE Intl 1-847-258-0300 Fax 1-847-574-7522 www.ohmite.com info@ohmite.com