CP1W-ETN01-US CP1 Ethernet Adapter Low Cost Ethernet Adapter for CP1 Series Micro PLCs The CP1W-ETN01-US is a low cost adapter that allows Ethernet communications to the CP1H and CP1L PLCs with an available option board slot. Easily connect the PLC to a NS HMI, Data Acquisition Software or CX-Programmer via Ethernet communications. Key Features and Benefits Easy Mounting The adapter mounts in an unused Option Board Slot of the CP1 PLC Supports 2 connections The CP1W-ETN01-US has been designed to allow 2 simultaneous Ethernet connections. An HMI (NS, NSJ, Indusoft) as well as a CX Programmer can communicate to a CP1H or CP1L with the adapter. Remote Maintenance Perform remote maintenance via an Intranet or the Internet for remote diagnostics to maximize production up-time and reduce operating and maintenance costs. Data Acquisition Use Indusoft or CX-Supervisor to easily monitor, control & store production data, alarms, recipes, messages from the PLC for improving product quality. Intelligent Slave Each PLC is a powerful motion controller* (CP1H - 4 Axis, CP1L 2 Axis) with high speed interrupts, Real Time Clock, IEC61131-3 Programming, PID, Floating Point Math and is expandable with analog or digital I/O. The addition of an Ethernet option board turns the PLC into an Intelligent Slave. *Transistor models Typical System Configuration NS HMI CP1H PLC W4S Ethernet Switch PLC Programming tool or Data Acquisition Package Intelligent Ethernet Slave In the above example the CP1H PLC communicates to the NS HMI via Ethernet. The PLC can control 4 axis of servo motors while also reading 4 high speed encoder inputs. An additional option port can be added for communications to AC Drives, Temperature Controllers, or other devices. Built into the CPU are 24 Digital In, 16 Digital Out and 6 Analog I/O (4 configurable analog inputs & 2 configurable analog outputs). The PLC is expandable up to 320 digital I/O along with 2 CJ Special I/O modules (Analog, Motion, RFID, Network or Communication cards). Specification Part Number Description CP1W-ETN01-US CP1 Ethernet Adapter Type 100Base-TX (Can be used as 10Base-T) Applicable PLCs CP1L-L14, CP1L-L20, CP1L-M30, CP1L-M40, CP1L-M60, CP1H Transmission Distance 100 m (distance between hub and node) Number of units mounted Two (both option ports can be used) (One for CP1L-L14,CP1L-L20) Communication Method Omron FINS Maximum connections per device Two connections (ie: CX-Programmer and NS HMI) Number of nodes on FINS network Up to 252 nodes possible FINS Frame Length 500 bytes max Default IP Address 192.168.250.11 Web Page IP Address Set-up