MC10H116FN ON Semiconductor

MC10H116 Triple Line Receiver Description The MC10H116 is a triple differential amplifier designed for use in sensing differential signals over long lines and is a functional/pinout duplication of the MC10116, with 100% improvement in propagation MC10H116 Table 1. MAXIMUM RATINGS Symbol Characteristic Rating Unit V Power Supply (V = 0) 8.0 to 0 Vdc EE CC V Input Voltage (V = 0) 0 to V Vdc I CC EE I Output Current Continuous 50 mA out Surge 100 T Operating Temperature Range 0 to +75 C A T Storage Temperature Range Plastic 55 to +150 C stg Ceramic 55 to +165 C Maximum ratings are those values beyond which device damage can occur. Maximum ratings applied to the device are individual stress limit values (not normal operating conditions) and are not valid simultaneously. If these limits are exceeded, device functional operation is not implied, damage may occur and reliability may be affected. Table 2. ELECTRICAL CHARACTERISTICS (V = 5.2 V 5%) (Note 2) EE 0 25 75 Symbol Characteristic Min Max Min Max Min Max Unit I Power Supply Current 23 21 23 mA E I Input Current High 150 95 95 A inH I Input Leakage Current 1.5 1.0 1.0 A CBO V Reference Voltage 1.38 1.27 1.35 1.25 1.31 1.19 Vdc BB V High Output Voltage 1.02 0.84 0.98 0.81 0.92 0.735 Vdc OH V Low Output Voltage 1.95 1.63 1.95 1.63 1.95 1.60 Vdc OL V High Input Voltage (Note 1) 1.17 0.84 1.13 0.81 1.07 0.735 Vdc IH V Low Input Voltage (Note 1) 1.95 1.48 1.95 1.48 1.95 1.45 Vdc IL V Common Mode Range (Note 4) 2.85 to 0.8 Vdc CMR V Input Sensitivity (Note 3) 150 typ mV PP PP 1. When V is used as the reference voltage. BB 2. Each MECL 10H series circuit has been designed to meet the specifications shown in the test table, after thermal equilibrium has been established. The circuit is in a test socket or mounted on a printed circuit board and transverse air flow greater than 500 linear fpm is maintained. Outputs are terminated through a 50 ohm resistor to 2.0 V. 3. Differential input not to exceed 1.0 Vdc. 4. 150 mV differential input required to obtain full logic swing on output. pp Table 3. AC CHARACTERISTICS 0 25 75 Symbol Characteristic Min Max Min Max Min Max Unit t Propagation Delay 0.4 1.3 0.4 1.3 0.45 1.45 ns pd t Rise Time 0.5 1.5 0.5 1.6 0.5 1.7 ns r t Fall Time 0.5 1.5 0.5 1.6 0.5 1.7 ns f NOTE: Device will meet the specifications after thermal equilibrium has been established when mounted in a test socket or printed circuit board with maintained transverse airflow greater than 500 lfpm. Electrical parameters are guaranteed only over the declared operating temperature range. Functional operation of the device exceeding these conditions is not implied. Device specification limit values are applied individually under normal operating conditions and not valid simultaneously.