EVBUM2614 RSL10-SENSE-GEVK (and RSL10-SENSE-DB-GEVK) User Guide Introduction www.onsemi.com The RSL10SENSE GEVK (and RSL10SENSEDBGEVK) is a comprehensive, EVAL BOARD USERS MANUAL compact, nodetocloud IoT sensor platform that allows development of various Bluetooth Low Energy based use cases. Along with the hardware and software, the RSL10SENSEGEVK includes a mobile app to interact with sensors and actuators. The board features RSL10, Industrys lowest power Bluetooth 5 SoC and several sensors from ON Semiconductor and Bosch. By combining motion, environmental, ambient light sensing with the ultralow power of the Bluetooth 5 Certified RSL10 and will enable customers to realize a new class of battery powered static, mobile and wearable smart sensors targeting consumer and industrial applications in the IoT. The overall deep sleep consumption of 20 A results in a battery life of over 1 year. For further increase in battery life, software configuration wizard allows flexible timing setup as discussed in the following sections. Figure 2. Variants There are two SKUs of the RSL10 Sensor kit. Both Scope variants are preloaded with an ultralow power firmware The board starts functioning as soon as the coin cell is in and include a 3 V CR2032 coin cell and a flexible NFC place. This document covers the setup, software antenna. architecture, documentation and provides instructions on downloading firmware to the board. The details regarding the mobile app and cloud connectivity are not covered in this document. Default Configuration In addition to the RSL10 SiP (SysteminPackage), the following sensors are present on the board. NOA1305, ambient Light sensor N24RF64, NFC EEPROM BME680, environmental sensor (temperature, humidity, pressure, air quality) Figure 1. BHI160 + BMM150, 3axis accelerometer, gyroscope, magnetometer. Together returnabsolute orientation RSL10SENSEGEVK: Firmware can be flashed via supported in software 10pin needle adapter (e.g. TC2050 from TagConnect) (not included). The 10pin header for debugger is not INMP522 > ultralow power microphone for audio populated on the board. applications User can insert NFC flexible antenna into dedicated RSL10SENSEDBGEVK: The debug (DB) version of the board also includes a low cost Segger debugger connector and bend underneath the battery holder for JLink LITE CortexM and a USB cable. Users can directly custom packaging / cases. debug/communicate/flash the firmware over the populatedpin header. Semiconductor Components Industries, LLC, 2019 1 Publication Order Number: September, 2019 Rev. 2 EVBUM2614/DEVBUM2614 Figure 3. Figure 4. Both kits are shipped with the ultralow power firmware preloaded into the boards. Powering the Board To power RSL10SENSE GEVK, one has to insert CR2032 (3 V) battery into battery holder located on the bottom side of the board. Figure 5. www.onsemi.com 2