MP240D4 Opto 22

MP Series SIP SSR Ratings to 4A @ 280 VAC or 3A @ 60 VDC Triac (AC) or Transistor (DC) output DC Control Normally open (AC or DC) or normally closed output (DC only) CE Compliant to EN60950-1 PRODUCT SELECTION Control Voltage 3A 3A 4A 3A 3-32 VDC MP120D3 MP240D3 MP240D4 MPDCD3 AVAILABLE OPTIONS AC OUTPUT SPECIFICATIONS (1) Description MP120D3 MP240D3 MP240D4 Operating Voltage (47-63Hz) [Vrms] 12-140 24-280 24-280 Transient Overvoltage [Vpk] 400 600 600 Maximum Off-State Leakage Current @ Rated Voltage [mArms] 5 5 5 Minimum Off-State dv/dt @ Maximum Rated Voltage [V/sec] (2) 200 200 200 Maximum Load Current [Arms] 3 3 4 Minimum Load Current [Arms] 0.02 0.02 0.02 Maximum Surge Current (16.6ms) [Apk] 90 90 130 Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.6 1.6 1.6 Maximum It for fusing (8.3 msec) [A sec] 36 36 72 Minimum Power Factor (with Maximum Load) 0.5 0.5 0.5 DC OUTPUT SPECIFICATIONS (1) Description MPDCD3 Operating Voltage Range [VDC] 3-60 Maximum Load Current [Arms] 3 Minimum Load Current [Arms] 0.02 Maximum Surge Current for 1 second [Adc] 5 Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.5 Maximum Off-State Leakage Current @ Rated Voltage [mA] 1.0INPUT SPECIFICATIONS (1) Description AC Output DC Output DC Output (-B) Control Voltage Range 3-32 VDC 3-32 VDC 3-32 VDC Must Turn On Voltage 3.0 VDC 3.0 VDC 1.0 VDC Must Turn Off Voltage 1.0 VDC 1.0 VDC 3.0 VDC Typical Input Current @ 32VDC 23 mA 23 mA 23 mA Nominal Input Impedance 1500 Ohm 1500 Ohm 1500 Ohm Maximum Turn-On Time [msec] 1/2 Cycle 100 s 100 s Maximum Turn-Off Time [msec] 1/2 Cycle 100 s 100 s GENERAL SPECIFICATIONS Description Parameters Dielectric Strength, Input/Output(50/60Hz) 4000 Vrms 9 Minimum Insulation Resistance (@ 500 VDC) 10 Ohm Maximum Capacitance, Input/Output 8 pF Ambient Operating Temperature Range -40 to 80C Ambient Storage Temperature Range -40 to 125C Weight (typical) 0.7 oz. (20g) Encapsulation Thermally Conductive Epoxy GENERAL NOTES 1) All parameters at 25C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443,13.11.1 3) Inductive loads should be diode suppressed MECHANICAL SPECIFICATIONS