CT-310 PMPI101 CT-310 REV: 03 12-2016 CRIMPING TOOL OPERATION INSTRUCTIONS CT-310 Panduit Corp. 2016 CRIMPING TOOL Crimp Area 0,5-1,0 22-18 OPERATION 1,5-2,5 16-14 INSTRUCTIONS Crimping Dies 4,0-6,0 12-10 for Panduit Heat Butt Splice Instructions Shrink insulated 1. Locate splice in proper crimp pocket. terminals, disconnects Center the crimp pocket over one-half of P/N94130 & splices with 22 to the barrel. WARNING: 10 AWG CU wire. 2. Insert stripped wire into crimp barrel. 3. Squeeze the handles firmly until Electric Shock Hazard: ratchet releases. Do NOT use this tool 4. Repeat for the other side of splice. on live wire. 5. Heat insulation with a heat gun or open flame until fully shrunk. Verify power is OFF before Ratchet working on wiring with this tool. Device The plastic grips are for the users comfort, to assure full cycle and are not intended to insulate against terminations. electrical shock while working on live electrical circuits. Crimp Crimp Area Direction Crimp Disconnect Instructions 1/16 Direction 1. Locate the disconnect in the proper crimp pocket. Center the crimp die over the crimp barrel. Ensure crimp is in direction shown. Covered 2. Insert stripped wire into crimp barrel. Handles 1/32 3. Squeeze the handles firmly until ratchet for better gripping releases. and comfort. Insulated Terminal Instructions 4. H eat insulation with a heat gun or open 1. Locate terminal in proper size die with edge of flame until fully shrunk. die 1/16 from front end of insulation. Insure crimp is perpendicular to the plane formed by the ring end terminal. 2. Insert stripped wire into terminal until a minimum of 1/32 of c onductor extends beyond barrel. 3. Squeeze the handles firmly until See Page 2 for ratchet releases. Crimp Die Go/No Go 4. Heat insulation with a heat gun or open flame Crimp Chart until fully shrunk. E-mail: Technical Support: techsupport panduit.com 1-800-777-3300 www.panduit.com Page: 1 of 2 Panduit Corp. 2016 OPERATION INSTRUCTIONS CT-310 TROUBLESHOOTING DIE CLOSURE INSPECTION Die closure is measured by using GO/NO GO gage members (dimensions listed in Table 1 below. Table 1 DIE CLOSURE GO / NO GO GAGE MEMBERS - TOOL NO. CT-310 CRIMP ENGLISH GO / NO GO GAGE MEMBERS METRIC GO / NO GO GAGE MEMBERS POCKET 2 G Dia. (GO) NG Dia. (NO GO) G Dia. (GO) NG Dia. (NO GO) AWG / mm 22-18 / 0,5-1,0 .078 .090 1,98 mm 2,29 mm 16-14 / 1,5-2,5 .098 .110 2,48 mm 2,79 mm 12-10 / 4,0-6,0 .139 .151 3,53 mm 3,84 mm Page: 2 of 2