32201 Parallax

599 Menlo Drive, Suite 100 General: info parallax.com Rocklin, California 95765, USA Technical: support parallax.com Office: (916) 624-8333 Web Site: www.parallax.com Fax: (916) 624-8003 Educational: www.stampsinclass.com Prop Clip ( 32200) Prop Plug ( 32201) USB to Serial Adapter for Propeller Circuits Introduction The Prop Plug and Prop Clip each provide a USB-to-serial port connection that is convenient for microcontroller programming and communication. These tiny devices are capable of asynchronous communication at up to 3 M baud with both 3.3-volt and 5.0-volt devices such as the Propeller and BASIC Stamp. The Prop Plug slips onto a 4-pin, 0.1 spaced male header, providing in-system programming of Propeller circuits in bread board, perf board and permanent projects which have the four-pin header. The Prop Clip is the same product, but designed for attaching to pads on the edge of a PCB. The Prop Clip could eliminate one part (a 4-pin header) from a PCB design for attaching the Prop Clip to the board. The electrical schematic for both parts is the same, based on the FTDI232R. The Propeller Demo Board ( 32100) and the Propeller Professional Development Board ( 32111) do not require the Prop Clip or Prop Plug both of these boards have the USB-to-serial circuit built into the PCB. The Propeller Proto Board (planned release Q1 2007) accepts the Prop Plug out of the box, and the layout also supports the USB2SER and the Prop Clip. Both products include the USB A to Mini B Retractable Cable ( 805-00010). Prop Clip Prop Plug Copyright Parallax Inc. Prop Clip/ Prop Plug ( 32200/32201) v1.3 11/17/2006 Page 1 of 5 PC Drivers Installation For Windows 2000/XP driver installation visit www.parallax.com and follow the USB Driver installation steps as shown below there is a link to troubleshooting instructions if needed. If you install the Propeller IDE, these drivers install automatically. Copyright Parallax Inc. Prop Clip/ Prop Plug ( 32200/32201) v1.3 11/17/2006 Page 2 of 5