PMM511A-RO PMK

PMM 511A-RO High impedance passive probe Features: TM CeramCore hybrid probe Coaxial design Interchangeable spring contact tips 0.8 and 0.38 mm diameter New IC contacting system for 0.8 to 1.27 mm pitch Read-out BNC connector The PMM 511A-RO is a 500 MHz, miniature 10:1 passive probe designed for instruments having 1 M input resistance. This probe is recommended for high performance probing applications and is adjustable for low and high frequencies. The probe is rated with 300 V CAT II maximum input voltage and complies with latest safety standards. Like every PMK passive probe the PMM 511A-RO features TM CeramCore technology. The probe s entire core is made of a high quality ceramic hybrid. Pure coaxial design and laser trimmed resistors ensure highest signal fidelity along the signal path offering high bandwidth and fast risetimes for accurate impulse measurements. All passive probes are equipped with PMKs signature spring loaded, needle sharp tips to support precise and safe measurements mini- mizing the risk of slipping off the board and produce a short circuit. Various types of tips are available. Besides the spring contact tips there is also a solid tip available at the users choice. Probe tips are interchangeable and can be replaced easily. Basic probe accessories and replacement tips are provided within the scope of delivery or can be purchased separately. See this datasheet and corre- sponding documents for further details. Thank you for your interest in our product 2007 PMK GmbH 1PMM 511A-RO Datasheet This datasheet supersedes all previously published material. Specifications that are defined typical are not guaranteed and are published as general information to the user. The instrument should have warmed up for at least 20 minutes and the environmental conditions must not exceed the spe- cified limits of the probe. Note that specifications are subject to change without notice. Electrical specifications (1) Attenuation ratio 10:1 2 % at DC Voltage coefficient 0.0025 % / V (typical) System bandwidth 500 MHz (-3 dB) System risetime 0.7 nsec (10 % 90 %) (typical) Maximum rated input voltage Measurement category I: 400 V rms 1250 V transient overvoltage Measurement category II: 300 V rms CAT II Pollution degree 2 Voltage derating Typical voltage derating PMM511A Measurement category I 400 300 Note that the max. input voltage rating of the probe decreases as the frequency of the applied signal 200 increases. 100 0 0,1 1 10 100 1000 Frequency MHz (1) Connect to oscilloscope with an input impedance of 1 M 1 %. 2007 PMK GmbH 2 Amplitude AC rms V sinus