FPR 4-T221 0R100 1%Q Powertron

FPR 4-T220 T221 Powertron FEATURES Resistances from 0.002Ohm to 10Ohms Power Rating to 15Watt Resistance Tolerances to 0.1% TCR to 30ppm/K Load Stability to 0.1% TO-220 Housing Convenient SMD D2Pak Available TABLE 1SPECIFICATIONS TYPE FPR 4-T220 FPR 4-T221 Resistance Range 0.002 to 10 Ohms Free air 70C 1.5 W Power Rating With heatsink 15 W Tolerances from 0.002 Ohms 1% / 2% / 5% from 0.01 Ohms 0.1% / 0.25% / 0.5% / 1% / 2% / 5% from 0.1 Ohms 0.1% / 0.25% / 0.5% / 1% / 2% / 5% Thermal Resistance 4.8 K/W 0.1% / 0.2% / 0.5% Stability (1000h) (depends on stress) 30ppm/K (20 to 60C) Temperature Coefficient other specifications upon request Voltage Proof 300 VDC Maximum Current 50 A Thermal EMF < 0.1V/K Operating Temperature Range -40 to 130C Resistor Material CuNiMn-Foil Substrate Anodized aluminium Housing PPS Connector Material Cu / tinned Terminals 4 Max. Torque 1 Nm 0.8 Nm ORDERING INFORMATION Part Number - Resistance - Contact - Tolerance FPR 4-T220 0.01 Ohms C 0.1% Document No.: 64238 For technical questions, www.powertron.de Revision: 25-04-2013 contact powertron vishaypg.com 1FPR 4-T220 T221 Powertron FIGURE 1TEMPERATURE COEFFICIENT 2000 0 Limit 2 -2000 -4000 Nominal R/R -6000 -8000 Limit 1 -10000 -40 -20 0 20 40 60 80 100 120 140 Temperature (C) FIGURE 2DERATING 120 0.5% 100 0.2% 80 0.1% 60 40 20 0 25 50 85 100 115 130 Temperature of the backplate (C) Power Rating Notes - The FPR Series Resistors must be attached to a suitable heat- sink. The maximum internal resistor temperature is 130C. To specify an appropriate heatsink use the following formula : R = T - ( P x R ) - T qH MAX qR A P Where: R = Thermal Resistance of Heatsink ( K/W ) qH R = Thermal Resistance of Resistor ( K/W ) qR T = Maximum Temperature of Resistor MAX T = Ambient Temperature of Heatsink ( C ) A P = Power Through Resistor ( W ) www.powertron.de For technical questions, Document No.: 64238 2 contact powertron vishaypg.com Revision: 25-04-2013 R/R (ppm) Power ( % from nominal power)