PEL00417

LED Floodlight with Microwave Sensor Models: SR09944, SR09945 & SR09946 IMPORTANT SAFETY INFORMATION Please read these instructions carefully before use and retain for future reference. This floodlight must be installed by a qualified electrician in accordance with current Building and IET Wiring Regulations. This product must be connected to Earth . The front of this floodlight is made of tempered glass, which cannot be replaced. Please take care while installing. If it gets damaged, the floodlight must be disposed of and replaced. LED lamps are extremely bright. To avoid possible damaged to the eyes, do not stare into an LED beam. In use, avoid touching any external surface of the floodlight due to the possibility of high temperatures. If the mains cord lead of this floodlight is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard. The floodlight can be mounted on normally flammable surfaces. The floodlight is suitable for use in an ambient temperature of between -30C and +45C. Terminal block is not included. Installation may require advice from qualified personnel. POSITIONING This floodlight is suitable for outdoor lighting applications, for domestic use only . Do not use in areas where an explosive or chemical atmosphere may exist. Do not use in areas where ventilation is restricted. It is suitable for mounting on plasterboard, wood or masonry surfaces. Highly flammable surfaces, such as polystyrene must not be used. Do not install on damp or conductive surfaces, such as metal. It should be placed away from any flammable materials. Before drilling any fixing holes, check that there are no hidden obstructions behind the mounting surface, such as pipes or cables. The recommended height for installation of the floodlight is between 1.8 and 2.5 metres. Ensure that there is space around the floodlight to allow adequate circulation of air . Orientation of the floodlight is important as the following images show . The floodlight has a beam angle of 120. It can be tilted upwards at an angle of approximately 60 and downwards at an angle of approximately 90. The angle of adjustment will vary slightly between models. INSTALLATION The floodlight is suitable for connection to a 200-240V, 50Hz, earthed supply. It is designed for permanent connection to fixed wiring, which must be a suitable circuit protected by an RCD and an MCB or fuse of the correct rating. Ensure that the mains supply is isolated before commencing the installation. Check that the floodlight is not damaged. If there is any damage, return it to the place where you purchased it. Do not attempt to repair it yourself. Choose your location to fix the floodlight, taking into account the guidance above. Use the floodlight bracket to mark the position of the fixing holes. Drill the fixing holes, and fix the floodlight into position using the appropriate size screws and wall plugs (not provided). Check that it is securely fixed. Connect the mains lead from the floodlight to an IP rated junction box. Ensure that the correct polarities for Live, Earth and Neutral are observed i.e. > Green/yellow - Earth terminal > Brown - Live terminal L > Blue - Neutral terminal N After wiring, check that there are no bare wires, all the wires have been correctly connected and that the cable restraint has been tightened.