Z-A431PJ31X-A

Z-BLOCKER Z-A431PJ31X-A Alarm Panel DSL Filter Description The Z-A431PJ31X-A is an Alarm Panel DSL Filter designed to allow to co-existence of DSL service in homes where security systems are installed. The Excelsus Alarm Panel DSL Filter isolates high-freqency DSL signals from low-fre- quency voice and data communication. Features Compatibility with most major alarm panels Z-BLOCKER Z-A431PJ31X-A Alarm Panel DSL Filter Allows reliable alarm panel reporting and cut-line protection Uninterrupted DSL communication during alarm panel line seizure and incident reporting RJ31X-RJ38X connections for line seizure and cut-line protection Over-voltage protection, protecting alarm panel from power surges Easy installation for service provider personnel less than 15 minutes to insert filter between alarm panel and phone line and perform a system test Compliant and Listed with FCC Part 68, CS-03, UL 60950 and CSA 22.2 60950 Block Schematic 1 Networking.PulseElectronics.com EX13 7.A (03/19)Z-BLOCKER Z-A431PJ31X-A Alarm Panel DSL Filter Z-BLOCKER Z-A431PJ31X-A Alarm Panel DSL Filter Specifications ADSL Insertion Loss (32 kHz to 1.1 MHz) 32 kHz to 300 kHz <8dB 300 kHz to 1.1 MHz <7dB Insertion Loss (1000 Hz) Short Loop <1.0dB Long Loop <0.75dB Insertion Loss (200 to 3400 Hz) Short Loop +3.5dB to -1.5dB Long Loop +3.5dB to -1.5dB Insertion Loss (3400 to 4000 Hz) Short Loop +10.0dB to -2.0dB Long Loop +10.0dB to -1.5dB DC Resistance in Ohms At Line port with POTS port shorted, Tip to Ring <25 At POTS port with Line port shorted, Tip to Ring <25 At any port with all other ports open, Tip/Ring to Ground >5M Longitudinal Balance - Two Port 200 to 1000 Hz >58dB At 3000 Hz >53dB Inter-Modulation Distortion at -9dB level Voice Band >57dB ADSL Band >60dB Envelope Delay (600 to 3200 Hz) Short Loop <200s Long Loop <200s Envelope Delay (3200 to 4000 Hz) Short Loop <200s Long Loop <200s Return Loss ERL >6dB SRL-L >5dB SRL-H >3dB SRL-H (2200 to 3400 Hz single frequency) >2dB Capacitance Tip to Ring >20nF Tip to Ring (without modem connected) <115nF At POTS port, Tip/Ring to ground <1nF DC Loop Current - Meets specifications between 0 and 100 milliamps DC Isolates dial pulses and on-hook/off-hook transitions from the digital subscriber line Length = 60mm, 150mm including cord and plug Width = 43mm Height = 22mm US Pat. No. 6,472,992 and 6,404,347 For More Information: Americas - prodinfonetworkamericas pulseelectronics.com Europe - comms-Apps-Europe pulseelectronics.com Asia - prodinfonetworkapac pulseelectronics.com Performance warranty of products offered on this data sheet is limited to the parameters specified. Data is subject to change without notice. Other brand and product names mentioned herein may be trademarks or registered trademarks of their respective owners. Copyright, 201 9. Pulse Electronics, Inc. All rights reserved. 2 Networking.PulseElectronics.com EX13 7.A (03/19)