KEELOQ REMOTE CONTROL SYSTEMS 12Vdc, 24Vdc Complete Remote Control System 1 3 Channels 12 / 24Vdc Supply High Security Protocol Easy Learn Feature Easy Installation Via Screw Terminals. Up to 7 Transmitters per System Relay Outputs 5A 230Vac Momentary or Latching Outputs Robust Enclosure Requires No Radio Licence Range up to 30 Metres Description A versatile general purpose remote control, which can be used for controlling many different applications. The system utilises the highly secure Keeloq code hopping protocol to ensure reliable operation. Easy to install, the receiver is connected using standard screw terminals provided. Power to the receiver is 12 or 24Vdc and the output(s) can switch up to 5A at 230Vac. The receiver outputs operate when the transmitter switch is pressed. The outputs can be set to momentary or latching operation. The system is supplied ready to plug and play, in addition a further 6 transmitters can be learnt by the receiver. Remote Control System Freq Range** Part Number Description (MHz) (Metres) QS1 AM System 1 Channel 433.92 30 QS2 AM System 2 Channel 433.92 30 QS3 AM System 3 Channel 433.92 30 Additional AM Transmitter Keyfobs Part Number Description QTX1 Transmitter Keyfob 1 switch QTX2 Transmitter Keyfob 2 switch QTX3 Transmitter Keyfob 3 switch ** Range stated is optimum, direct line of sight. In worst conditions this can be reduced. DSQS-3 Sept 07 2007 Page 1 NC COM NO NC COM NO KEELOQ REMOTE CONTROL SYSTEMS 12Vdc, 24Vdc Data Outputs Each output relay provides an isolated switch. Connections are Common (COM), Normally Open (NO) and Normally Closed (NC). Relay Connections when Relay Connections when Transmitter NOT Operating Transmitter OPERATING The action of the relay outputs is set by the SIL1 Option link setting. A link is made / removed by the small shorting link cap placed over the pin header. Option Fitted = Momentary Operation Option Not Fitted = Latching Operation Please Note: The relay contacts in this unit are for functional use only and must not be used for isolation purposes Learning a New Transmitter Keyfob Switch 1. Short the two SW1 learn pins on the receiver PCB, the receiver relays will click continuously. 2. Press the transmitter once, the receiver relays will stop 3. Press the transmitter again, the receiver relays will buzz briefly. This transmitter will now operate the system. Erasing Existing Transmitters 1. Short the two learn pins on the receiver for 10 seconds. 2. The receiver relays will buzz briefly after the 10 seconds to indicate the Tx encoder(s) have been erased NOTE: You can not erase individual Tx encoders Technical Specifications Transmitter Keyfob Battery Type GP23AE (supplied) Electrical Characteristics Min Typical Max Units Supply Voltage 8.5 9 16 Vdc Supply Current : Quiescent 0 mA Supply Current : Transmitting 8 mA Operating frequency 433.92 MHz Receiver Decoder Dimensions 96mm x 55mm x 29mm ELECTRICAL CHARACTERISTICS MIN TYPICAL MAX DIMENSION Supply Voltage for +12Vdc 11 12 13 Vdc for +24Vdc 23 24 25 Vdc Supply Current: Quiescent 14 mA All relays operating 140 mA sales quasaruk.co.uk www.quasaruk.co.uk DSQS-3 Sept 07 2007 Page 2