RACD03-500-PSE

700mA 600mA 500mA 350mA 300mA 0mA R w a A r E r 3W Class II AC-DC LED Power Supply Features 350mA, 500mA and 700mA CC/CV Output AC/DC Converter Fused Input and SCP, OVP, OLP, OTP 3.75kVAC Isolation LED IP66 Rated Driver Low Cost RACD03-PSE Description 3 Watt A compact universal AC input 3W constant current switching power module suitable for driving 1 - 6 3 high power LEDs. The output (dual constant voltage / constant current mode) current limit is fixed at CC/CV 350mA, 500mA or 700mA. At lower output currents, the output is constant voltage. Connections are via 118mm long flying leads. Single Output Selection Guide (1) Part nom. Input CC CV Efficiency Rated Number Voltage Range Mode Mode typ. Power nom./max. (VAC) (VDC) (mA) (VDC) (mA) (%) (W) RACD03-350-PSE 100-120 3-12 350 15 0-300 72 3 / 4.2 RACD03-500-PSE 100-120 3-9.5 500 none 71 3 / 4.6 RACD03-700-PSE 100-120 3-4.5 700 6 0-600 62 3 / 3.15 All LED Drivers may not be used without a load. They must be switched on the primary side only. Noncompliance may damage the LED or reduce its lifetime. Specifications (measured at T = 25C, nominal input voltage, rated load after warm up) a BASIC CHARACTERISTICS Parameter Condition Min. Typ. Max. Input Voltage Range -10% +10% Output Voltage Range 3VDC 15VDC Input Current full load, 100VAC 110mA Input Frequency Range 47Hz 63Hz Hold-up Time 18ms Output Ripple Current 0.1Ap-p (1) Constant Current (CC) and Constant Voltage (CV) CV RACD03-350-PSE 15V RACD03-500-PSE J61347-1(H20) Certified 12V RACD03-700-PSE J61347-2-13(H21) Certified 11V J55015(H20) Certified 9.5V CV 6V 4.5V CC CC CC 3V Output Current Nominal Current Limits Notes: Note1: CV Mode is approved by Recom internal quality standard, but not certified according UL. www.recom-power.com REV.: 0/2016 L-1 a Y n t 3 y Output VoltageRACD03-PSE AC/DC Converter Series Specifications (measured at T = 25C, nominal input voltage, rated load after warm up) a PROTECTION Parameter Condition Value Input Fuse T1A, slow blow Short Circuit Protection (SCP) continuous, current limit Overload Protection (OLP) 120% typ. 350mA 17V max. Output Over Voltage Protection (OVP) Zener Diode Clamp 500mA 14V max. 700mA 8V max. Over Temperature Protection (OTP) Shutdown, automatic resatart after cooling down Isolation Voltage I/P to O/P 3.75kVAC / 1 minute Maximum loading of automatic circuit breakers* * 115VAC, 1Ohm, 90 phase angle and max. load Circuit Breaker Circuit Breaker Current Typ 10A 16A 20A 25A C 221 247 337 430 ENVIRONMENTAL Parameter Condition Value Operating Temperature Range -20C to +40C, Ambient Max. Case Temperature . +75C IP Rating IP66 Operating Humidity 5%-85% RH, non condensing 3 Design Lifetime +25C ambient 20 x 10 hours Derating Graph 100 80 60 40 20 0 -20 -10 0 10 20 30 40 50 Ambient Temperature (C) SAFETY AND CERTIFICATIONS Certificate Type (Safety) Standard J61347-1(H20) Safety of control gear for LED modules J61347-2-13(H20) EMC Compliance Standard / Criterion Radio disturbance characteristics of electrical lighting equipment J55015(H20) L-2 REV.: 0/2016 www.recom-power.com Output Current (%)