Universal AC Input Features Constant Voltage / Constant Current Operation LIGHTLINE Active Power Factor Correction IP67 Design for Indoor and Outdoor Use LED DRIVER AC/DC-Converter Cooling by Free Air Convection with 5 year Warranty PSE Certified for Japan market Description The RACD100-PSE LED driver series offer 100W of power with a universal input voltage range of 90-130VAC and constant current output up to 8.3A at a voltage of approximately 12V. The series feature a unique dual mode operation for either constant current or constant voltage making them suitable for driving LEDs directly or via local 100 Watt constant-current DC/DC modules directly on the light engine board. The RACD100-PSE series are fully sealed IP67 LED drivers and therefore ideally suited for indoor and outdoor applications including road, street and walkway lighting, high-bay, LED signage, and outdoor area lighting for car parks, public buildings, and tunnels. The LED Single drivers are PSE certified and come with a 5 year warranty. Output Selection Guide Part CV Mode CC Mode Efficiency Number Constant Voltage Current Range DC Voltage Range Constant Current (115VAC) (V) (A) (V) (A) (%) RACD100-12-PSE 12 0-8.3 9-12 8.3 87 RACD100-24-PSE 24 0-4.2 14-24 4.2 87 RACD100-36-PSE 36 0-2.8 26-36 2.8 89 RACD100-48-PSE 48 0-2.1 34-48 2.1 88 Specifications Input Voltage Range 90-130 VAC or 127-184VDC Input Frequency Range 47-63Hz. RoHS 2011/65/EU Power Factor Full Load, 115VAC >0.98 6/6 THD Full Load, 115VAC 8% max. AC Current 115VAC 1.4A max. Input/Output Isolation 3.75kVAC / 1minute RACD100-PSE Input/Case Isolation 1.8kVAC / 1minute Output/Case Isolation 0.5kVAC / 1minute Leakage Current <0.75mA Voltage Tolerance -1% to 5% Start-up Time Full Load, 115VAC 1.5s Ripple & Noise (at 20MHz bandwith) 150mVp-p max. Over Current Protection 95%-105% rated current Auto-Recovery Short Circuit Protection Hiccup Mode Over Voltage Protection 12V 15V typ. Latch Mode 24V 31V typ. (Power off to recover) 36V 45V typ. 48V 58V typ. Note: Over Temperature Protection Tcase 95C 10C All LED Drivers may not be used without a load. Operating Temperature Range without derating -20C to +50C( see graph) They must be switched on the primary side (free air convection, according to PSE) Case Temperature 75C max. only. Noncompliance may damage the LED or Operation Humidity 20%-90% RH Non-Condensing reduce its lifetime. Storage Temperature -40C to +80C Storage Humidity 10%-90% RH Vibration 10-500Hz, 2G, 60 Min. along X, Y and Z IP Rating IP67 EMC Standards (designed to meet) EMC Compatibility EN55015 FCC, Part 15 Harmonic Current EN61000-3-2 Class C (75% load) EN61000-3-3 EMC Immunity EN61000-4-2, 3, 4, 5, 6, 11 Refer to Application Notes continued on next Page L-60 REV: 0/2015 www.recom-power.comRACD100 -PSE RACD100-PSE LIGHTLINE AC/DC-Converter Series Specifications PSE Certification J61347-1(H20), J61347-2-13(H21), J55015(H20) Dimension 222*68*39mm Weight 1020g MTBF using MIL-HDBK-217F (25C) 250 x 10 hours Design Lifetime 70 x 10 hours The use of a circuit breaker with C-characteristic is recommended. Derating Curves B + A A . A . A - A - A , A , A A A 0 * + / 3 + * 8 2 2) - ) Typical Characteristics Constant Voltage / Constant Current Curve 7) 0 7) 0 , 7) 0*- 7) 0,. 2 2 2 2 2 2 2 2 , *- ,. 2 2 2 2 3 , - *, .%* ,% %. % 8 8 8 8 Maximum Number of LED drivers per circuit breakers Condition Circuit Breaker Circuit Breaker Current Typ 10A 16A 20A 25A 115VAC, 1Ohm C 7 12 14 18 90 phase angle Package Style and Pinning 2 5 % %, 33% /% .%3 -.% * *,% * ) 6 2 < % +6* ) 69 4 (> 33%- ( 12 7 *,% 2 < % 6 6= 5 02 4 (> .%3 2 5 *+ + *+ + * * *3% The product information and specifications are subject to change without prior notice. RECOM products are not authorized for use in safety-critical applications (such as life support) without RECOMs explicit written consent. A safety-critical application is defined as an application where a failure of a RECOM product may reasonably be expected to endanger or cause loss of life, inflict bodily harm or damage property. The buyer shall indemnify and hold harmless RECOM, its affiliated companies and its representatives against any damage claims in connection with the unauthorized use of RECOM products in such safety-critical applications. www.recom-power.com REV: 0/2015 L-61