RECTRON SEMICONDUCTOR FM2500W TECHNICAL SPECIFICATION HIGH VOLTAGE RECTIFIER VOLTAGE 2500 Volts CURRENT 0.15 Ampere FEATURES * Low cost * Low leakage * Low forward voltage drop * High current capability SMX MECHANICAL DATA * Case: Molded plastic .209 (5.31) * Epoxy: Device has UL flammability classification 94V-O .185 (4.70) * Lead: MIL-STD-202E method 208C guaranteed .110 (2.79) .067 (1.70) * Mounting position: Any .086 (2.18) .051 (1.30) .091 (2.31) .011 (0.28) .067 (1.70) .007 (0.18) .180 (4.57) .160 (4.06) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS o Ratings at 25 C ambient temperature unless otherwise specified059 (1.50) .035 (0.89) Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in inches and (millimeters) o MAXIMUM RATINGS (At TA = 25 C unless otherwise noted) RATINGS SYMBOL FM2500W UNITS Maximum Recurrent Peak Reverse Voltage VRRM Volts 2500 Maximum RMS Volts VRMS 1750 Volts Maximum DC Blocking Voltage VDC Volts 2500 Maximum Average Forward Rectified Current IO Amps o 0.15 at TA = 50 C Peak Forward Surge Current, 8.3 ms single half sine-wave Amps IFSM 30 superimposed on rated load (JEDEC method) Peak Forward Surge Current, 10 ms single half sine-wave IFSM Amps o 3.0 superimposed on rated load at 105 C (JEDEC method) Typical Junction Capacitance (Note) CJ 35 pF 0 Operating and Storage Temperature Range TJ, TSTG -55 to + 150 C o ELECTRICAL CHARACTERISTICS (At TA = 25 C unless otherwise noted) CHARACTERISTICS SYMBOL FM2500W UNITS Maximum Instantaneous Forward Voltage at 0.15A DC 2.0 VF Volts o Maximum DC Reverse Current TA = 25 C 5.0 uAmps o at Rated DC Blocking Voltage TA =100 C IR 50 Maximum Full Load Reverse Current Average, Full Cycle o 30 uAmps .375, (9.5mm) lead length at TL = 75 C 2004-8 NOTES : Measured at 1 MHZ and applied reverse voltage of 4.0 volts010 (0.25) .008 (0.20)( ) RATING AND CHARACTERISTIC CURVES FM2500W FIG. 1 - TYPICAL FORWARD CURRENT FIG. 2 - MAXIMUM NON-REPETITIVE FORWARD DERATING CURVE SURGE CURRENT 150 70 Single Phase Half Wave 60Hz Inductive or 60 8.3ms Single Half Sine-Wave 120 Resistive Load (JEDEC Method) 50 90 40 30 60 20 30 10 0 0 0 50 100 150 175 1 10 100 AMBIENT TEMPERATURE, ( ) NUMBER OF CYCLES AT 60Hz FIG. 3 - TYPICAL REVERSE CHARACTERISTICS 10 1.0 T = 25 J 0.1 .01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) RECTRON AVERAGE FORWARD CURRENT, (mA) INSTANTANEOUS REVERSE CURRENT, (uA) PEAK FORWARD SURGE CURRENT, (A)